8/12/2019 X50 Manual

1/4

SE AUDIO

28.12.2012

SE X50

v1.0

I N F O R M A I O N

MANUAL

www.TSEAUDIO.comwww.theserinaexperiment.net

8/12/2019 X50 Manual

2/4

TSE X50 v1.0

IntroductionAfter years in part time development X50 final version is finally ready for the public.

The hours spent on this project are countless, going back and forth finding the best possible way

capturing the response of the original hardware while keeping the cpuusage on a usable level for

users with a mid to highend system has been a challenge for sure. This project has actually been

discontinued at least ! times because it didn"t meet my e#pectations.

The amp is modeled against a schematic of the original unit and every stage is taken into account

with minimal simplifications. A few features from the betaversion such as biasing is removed.

$eep in mind this is a digital emulation and some aspects of the original sound might not be there.

This plugin doesn"t try in any way to replace the original hardware, %f you like the plugin, you would

like the original analog hardware even more &'

(odeled)*rogrammed in + by on-el /ohn Adrian /ohansen'.

Features %nput evel1 +ontrol the incoming guitar' signal. 2alue of 3.0 4 0d and 6.0 4 7d

8utput evel1 +ontrol the outgoing amp' signal.

*re9ain1 *reamp gain, this is the main dirt control of the amp.

ow, (id, :igh1 Tonestack);

8/12/2019 X50 Manual

3/4

TSE X50 v1.0

Pre Amp:The green channel is modeled from the ($3 version of the amp. The amp has no clean channel,

even though you could get a clean"ish sound with break ups by using very low *re9ain and high

*ost9ain. %mprovements on this channel will be done in later updates.

The red channel is modeled from both the ($3 and ($6 versions. The technical difference is so

small that it was easy to implement both.

Power Amplifier - Using the preamp/poweramp bypass functions:The power amp has two types of tubes, 779+ and ;!B, the ow;nd)*resence controls reacts a

little different on each tube because of gain difference in the tubes.

The power amplifier consists of a phase splitter 6# 36AX?', B# powertubes and a speaker model.

Dsing a speaker model you get a ow;nd)*resence control that reacts to the virtual' speaker

impedance gives you a more realistic fre

8/12/2019 X50 Manual

4/4

TSE X50 v1.0

'inimum (ystem )e*uirements:

+*D must support CC;6 instructions. *entium B ) A(E Athlon X*'

!6 bit or 7B bit Findows X* ) 8CX 30.5 ) or higher.

EAF ) AD ) 2CT host @eaper or similar'

A processor of %ntel type i5)i? +*D is recommended for the best e#perience..

A big thanks to the users of TC; ADE%8 plugins

+I( I( A F),,A), P).U0

,12.3!

- 2ohn A4 2ohansen / on5el -

www4(,AUI.4com

www4theserinae%periment4net

http://www.tseaudio.com/http://www.tseaudio.com/