woodwork tools 2 quiz marking gauge mortise gauge cutting gauge 1.what is the correct name for this...
TRANSCRIPT
2. Which of the following tools would be used to rip a standard sheet of 9mm Plywood in half?
A Panel Saw
A Coping Saw A Tenon Saw
A Jnr Hacksaw
Through Housing Joint
Mortise & Tenon Joint
Cross Halving Joint
5.Which joint is this tool normally used to mark out?
Rebate Joint
Dovetail Joint
Stopped Housing Joint
Roll the pincers as shown
7. Which picture shows the correct way to use these pincers ?
Pull the pincers as shown
8. Which of the following tools would be used to start a small hole for a screw?
A Scriber
A Countersink Drill
A Nail Punch
A Bradawl
9. What is the blade of a Panel saw made from?
Cart Iron
Spring Tempered Tool Steel
Bright Drawn Mild Steel (BDMS)
Stainless Steel
10. What is the correct name for the tool being used in this picture?
Mortise Gauge
Cabinet Scraper
Sliding Bevel
Cutting Gauge
Router
11. What is the correct name for the tools shown below?
Centre Punch
Parallel Punch
Nail Punch
Dot Punch
Hollow point
13. Which of the following tools would be used for marking out angles other than 90˚
Odd Leg Callipers
A Try Square An Engineers Square
A Sliding Bevel
Drawing lines parallel to an edge
Marking out Circles Centre Punching Holes
14. What are Trammels normally used for?
Marking out Mortise Joints
Dovetail Saw
Fret Saw
15. What is the correct name for this tool?
Bow Saw
Flush Cut Saw
Piercing Saw
Coping Saw
Panel Saw