wireless outdoor bridge quickly installation guide
TRANSCRIPT
Wireless Outdoor BridgeQuickly Installation Guide
1.Device Installation 1
2
3.Bridge Ways 34.Channel Table 13
2.Connection Topylogy
1.Device Installation (Take the 5.8g wireless bridge as an example)
Passive PoE adapter supports up to 60 meter(200 feet) Power over Ethernet deployment
Connect the PoE adapter’s LAN to PC,router or switch
Please prepare a long enough network cable toconnect the POE adapter and CPE.Recommendto use a Cate5 (or above) shielded networkcable with a ground wire.
Only applicable to areasbelow 2000 meters above sea level
Only applicable to areas tonon-tropical weather conditions
1
2.Connection Topylogy Point to Point
IP Camera - Switch - Wireless BridgeWireless Bridge - DVR - Monitoring PC
IP Camera - Wireless BridgeWireless Bridge - DVR - Monitoring PC
Point to multiple point
H C
H C
H C
H C
H C
2
(*Two bridge ways:One Key Bridge & LED Display Bridge)3.Bridge Ways
Quick Installation Guide
1.One Key Bridge1.Config Master/Slave CPE
Put the switch to H,CPE will work as Master.Put the switch to C,CPE will work as Slave.
2.Point to Point ConnectionPress reset button on both master and slave CPE,will start bridging.
Point to Mult Point ConnectionPress reset button on master and mult slave CPE,will start bridging.
Note:Mater CPE and slave CPE bridging actions (press reset button) need to be finishedin 1 minute.
*Note:The pictures of the above products may change slightly according to theproduction cycle,and the final apperance is based on the physical object.
H C
H C H C
H C
H C
3
3.Point to Point ConnectionPress reset button on both master and slave CPE,will start bridging.
2.LED Display Bridge1.Config Master CPE
2.Config Slave CPE
Point to muit Point Connection
When bridge two CPEs,make one work as master:press “F” to make H/C blinking,and press “S” to change to “H”,it will save automatically in 5 seconds
Set another CPE to work as slave:press “F” to make H/C blinking, and press “S” to changeto “C” ,it will save automatically in 5 seconds.
Press reset button on master and mult slave CPE,will start bridging.
Note:
1.CPE default working mode is AP mode after reset,IP is 192.168.188.2532.F is select button,can be used to choose master/slave working mode,wifi channel,IP,andchecking signal strength.3.S is config button,can be used to set master/slave working mode,wifi channel,IP.
Note:Master CPE and slave CPE bridging actions (Press reset button) need to be finished in 1 minute,
4
5
6
7
8
9
10
11
12
13
14
Wuhan MokerLink Technology Co.,LtdRm10,13/F,Main Building 7,Changhang Lanjing International,No.116 Gaoxin Ave.,Hongshan Dist.,Wuhan,Chinahttp://[email protected]
For technical support and other information, please visithttp://www.mokerlink.com/support/