wireless exam (94.3)
TRANSCRIPT
1 The ACU site survey tool can operate in which modes? (Select two.)repeater mode
stand-alone mode
passive mode
active mode
parallel mode2 What is the difference between higher gain antennas and lower gain antennas? (Select two.)
Higher gain antennas direct energy more precisely.
Higher gain antennas have narrower beamwidths.
Higher gain antennas have a greater chance of receiving interference.
Higher gain antennas have lower bandwidths.3 Which topics may be included in the Request for Proposal? (Select three.)
prices and payment options
workstations and servers specifications
an implementation plan
a network topology for the new design4 Which types of transmission medium are available for use by WLANs? (Select two.)
fiber-optic
infrared light
UTP
radio frequencies
STP5 Which statements describe the RF spectrum? (Select two.)
It encompasses both radio waves and microwaves.
Most of the frequencies in the spectrum are unlicensed.
It extends from about 9 MHz to thousands of GHz.
It is used heavily for communications.
The acronym stands for radiated frequency (RF).6 What are the effects of multipath interference? (Select two.)
distorted signals at the receiving end
increased coverage range
poor signal quality levels
enhanced data throughput
incorrect polarization
7 What is the best way to test the line-of-sight path when doing a site-to-site survey?visually
with a spectrum analyzer
both visually and with a spectrum analyzer
visually and with a Global Positioning System8 At which OSI layer or layers does a wireless AP operate?
Layer 1
Layers 1 and 2
Layer 2
Layers 2 and 39 What causes the Status LED to blink green in a 1200 series AP?
transmitting/receiving packets
no devices associated
general warning
no special meaning10 In the United States, how many nonoverlapping channels are there for the 802.11b standard?
three
four
seven
eight11 Which type of antenna is referenced as a base in a dBd rating?
plane
yagi
dipole
isotropic12 When using high gain omnidirectional antennas, what is helpful in reducing the poor coverage below the
antenna?diversity
polarization
amplifiers
downtilt13 For a standard survey, how much overlap is sufficient to provide transparent handoffs between APs?
10%
15%
20%
25%
30%14 Which two spread spectrum modulation techniques are used by WLANs? (Select two.)
FDSS
ODSS
DSSS
DFSS
FHSS15 Which type of antenna connectors are used by the Cisco Aironet Bridges?
polarized BNC
reverse TNC
polarized TNC
reverse BNC16 Which types of software should be installed on laptops to prevent harmful disruptions while they are operating
on public wireless networks? (Select two.)spectrum analyzer
antivirus
firewall
protocol analyzer
repair utility17 Which frequency spectrum do FHSS WLANs use in the United States?
83 Mhz around the 5 Ghz ISM band
83 Mhz around the 2.4 Ghz ISM band
900 Mhz around the 5 Ghz ISM band
900 Mhz around the 2.4 Ghz ISM band18 What does a wireless bridge associate with if it is configured as Root=ON?
clients and repeaters only
other Root=ON devices
Master bridge
no device since it is in maintenance mode19 When configuring the AP Radio Port Hardware setup page, which settings are recommended in situations where
communication is poor and many client devices are associating with the access point?low fragment threshold and high RTS threshold
high fragment threshold and high RTS threshold
high fragment threshold and low RTS threshold
low fragment threshold and low RTS threshold20 Which open standard operating system is licensed for use in many mobile computing devices?
Symbian
MS DOS
Windows XP
OS/221 Bit Flipping, Replay Attacks, and Weak IV collection are all considered attacks against which type of security?
WEP
LEAP
PEAP
IPSec22 What frequency or frequencies does the IEEE 802.11 standard utilize?
900 MHz
3.4 GHz
5.4 GHz
2.4 GHz and 5 GHz
900 MHz, 2.4 GHz and 5.4 GHz23 In a WLAN, what is the purpose of the common DS?
to allow communication between multiple BSSs thereby allowing mobile devices to roam without loss of connectivityto reduce the number of APs needed to provide reliable connectivity while roaming
to eliminate the need for connectivity to a wired network
to eliminate the need for station addressing when in roaming mode24 During a routine wireless benchmark inspection, the IT personnel of the bank discovered that the AP in the
lobby was transmitting at 60 mW. The AP connects to a 6-dBi gain omni-directional antenna through a cable with a 3-dB loss. What is the final power output radiated by the antenna element?
30 mW
60 mW
120 mW
180 mW25 What is the behavior of a wireless bridge when configured as a root bridge?
It associates and communicates with any wireless device on the network.
It associates and communicates only with other root bridges.
It associates and communicates with multiple non-root bridges but only a single root bridge.It associates and communicates with multiple non-root bridges but will not communicate with other root bridges.
26 What are the two methods used by wireless clients to connect to an AP according to the IEEE 802.11 standard? (Select two.)
open authentication
shared key authentication
private key authorization
closed authentication
restricted authentication27 Which command is used to set the parent AP for a repeater AP?
AP(config)# parent 10.0.0.1
AP(config-if)# parent 1 10.0.0.1
AP(config-if)# parent 1 abcd.1234.ab12
AP(config)# parent abcd.1234.ab1228 Which three power modes are available on a Wireless NIC? (Select three.)
CAM
FastCAM
PSP
FastPSP
FastAPA29 Which device decodes the various protocol layers in a recorded frame and presents them as readable
abbreviations or summaries?cable tester
network analyzer
spectrum analyzer
time domain reflectometer30 What are the keys to maintaining a problem-free network environment and having the ability to isolate and fix a
network fault quickly? (Select three).communication
data backup
documentation
planning
virus protection
fault tolerance
31 What is the best tool to use if there may be a radio interference problem?cable tester
gauss meter
spectrum analyzer
time domain reflectometer32 What are the three basic options for configuration on a Cisco Aironet 350 series bridge? (Select three.)
Web-browser interface
SNTP
CLI
CDP
SNMP
SSID33 Which type of threats originate from hackers who are more highly motivated and technically competent?
external
internal
structured
unstructured34 Which of the following statements are correct? (Select two.)
Longer cables lose more power than shorter ones.
Thick cables lose more power than thin ones.
Higher frequencies lose more power than lower ones.
Rigid cables lose more power than flexible ones.35 Cisco Aironet bridges operate at which layer of the OSI model?
physical
data-link
network
transport36 What is a good antenna to use with an AP to provide coverage for a long indoor hallway?
5.2 dBi Ground Plane
8.5 dBi Patch Wall
2.15 dBi Rubber Dipole
2.2 dBi Ceiling Mount37 What is the WEP key size specified in the 802.11 standard?
256 bit
64 bit and 128 bit
40 bit and 128 bit
40 bit38 How does an AP behave when the receive antenna is set to diversity?
It will use the antenna that receives the best signal.
It will use both antennas at the same time.
It will round-robin between the two antennas.
The AP will always use one antenna to transmit and the other to receive.39 When using the site survey tool, a specific mode causes the client adapter to actively send or receive low-level
RF packets to and from its associated AP and provides information on the success rate. Which mode accomplishes these functions?
repeater mode
stand-alone mode
passive mode
active mode
parallel mode40
In the graphic, which type of cable should be used at the arrow to protect the WLAN against a direct lightning strike?
coax
fiber-optic
Category 5
UTP
41 dBm is a reference to which unit of measure?milliWatt
microWatt
Watt
kiloWatt42 At which layer of the OSI model do wireless bridges and APs operate?
Layer 4
Layer 3
Layer 2
Layer 143 How wide of a band of frequencies is used by 802.11b DSSS?
5 Mhz
11 Mhz
22 Mhz
24Mhz44 When a WLAN is being designed to expand an existing LAN, what should be done during the design phase?
(Select three.)Select the carrier.
Learn about the current topology and physical structure.
Study the actual network performance.
Provide an estimation of costs for the new equipment needed.
Identify the links that must be replaced.45 Access points often have two antennas attached to them for diversity in signal reception. What are two purposes
of this diversity? (Select two.)helps prevent multipath distortion
helps increase signal strength
helps eliminate null coverage areas
helps prevent diffraction and scattering of the signal46 Why do APs have two antennas attached to them?
to increase coverage area
to provide diversity
to provide redundancy
to provide symmetry47 In addition to physically installing the client adapter card into the wireless station, what is needed for
functionality of the card?a universal client adapter software driver
an interoperability software patch
a client adapter driver with its corresponding AP driver
a client adapter software driver specific to the OS48 Most data collection devices operate at which speed?
1 Mbps
2 Mbps
5 Mbps
11 Mbps49 In DSSS technology, each data bit becomes a chipping sequence. How many chips per bit are used by the IEEE
802.11 standard?11
12
13
1550 In WLAN data transmission, what is the significance of having four different IFS intervals?
to increase the amount of data that can be transmitted at one time
to prevent collisions when accessing the wireless media
to resequence data units at the destination STA
to provide priority levels for access to the wireless media