who we are · pdf filedorma manet-sliding architectural hardware for furniture sliding door...
TRANSCRIPT
1. Wood, Steel & Aluminum Hardware Accessories
International Standards • EN Standard 500,000 Cycles • ANSI Standard 1,000,000 Cycles • UL Standard 100,000 Cycles EN Standards more restrictive compared to the other ones due to performance at the end of durability ( 500.000 cycles ) to be not below 80% ( for ANSI after 1Ml cycles same performance not requested ) but added value element in terms of quality
and product life
Durability
Different Patch Fittings
• thickness up to 19 mm • Max door width 1300 mm &Max height 2500mm • Max door weight 130 KG
B-Types of Rail Solutions
TP : door rails for center hung TA : door rails for offset hung • 76.5 mm width for glass thickness from 8 to 12 mm • 100 mm for glass thickness more than 13.5,15,17,21 mm
Using Rails If the weight higher than 130 kg or width >1300mmIn order to protect the door and avoid damage.
Note Fixing Without any Cutting out of Glass
From Bottom
• Concealed glass Door closer with transom in case of top Glass Panel ,RTS 85 EN 3 (95 cm&60 KG),back check Hold open at 90˚.
From Top
Assembly for the Visur Solution
Transom where RTS 85 Fixed in it Max Panel Width 1100mm.
Component of Visur Depth of installation 64 mm & diameter of bearing housing 126mm .
D – Beyond Solution Maximum safety and stability in the swing door systems that Preventing the risk of trapped fingers
• Suitable for Glass with thickness 10&12 mm • Max Panel width 1000 mm incase of fixing to glass • Max Panel width 1200 mm incase of fixing to wall
Short pivoting Rod
If length is more than 2200 mm we must use continuous pivoting rod
• Max Panel width 1000 mm incase of fixing to glass • Max Panel width 1200 mm incase of fixing to wall
continuous pivoting rod
D- EA Solution
Single action offset door, hinge to frame or integrated Glass incase of offset applications ( Room Server)
• Suitable for Glass thickness 8,10,12 mm • Max door width 1000 mm • Max door weight 80 KG
E-Tensor
Fixed to Glass Fixed to Wall
A Creatively Solution double action door hinge & Self closing For Glass Hold open at angle 90˚& self closing start from 80˚ even at 2°self closing occur .
• Max Door Weight 65 KG • Available for Glass thickness (8,10,12)mm • Min Door Panel Width is 700 mm & Max 1000 mm • 500,000 operating cycle test
• Suitable for Single and double action glass doors
• If Door Length is higher than 2 m you should use Continues Pivot
Product Range - Internal Doors
DORMA Studio Slim in form and elegant in design
DORMA Junior Office Reliable and multifunctional
DORMA Studio ARCOS Attractive accents in design
DORMA ARCOS Office Strong pieces in glass
FLOOR SPRING (EUROPEAN STANDARD)
BTS 65 An inexpensive floor spring for double action doors Available in fixed size, EN 4 Max leaf weight 100 Kg Tested to EN 1154 Fixed hold open point at 90° CE marked
BTS 80 Designed for all types of door Available size EN3, EN4, EN5 Max leaf weight 300 Kg Backcheck as standard feature Adjustable hold open Number of optional accessories available for
this model Also available are 80F, 80EMB, 80FLB in EN4,
EN5 & EN6
BTS 75 V Adjustable size EN 1 – 4 Max leaf weight 120 Kg Suitalbe for Fire & smoke check doors Backcheck as standard feature Hold open point at 90° or 105° CE marked
DORMA Swing door operator
ED 100–Electro mechanical operator
Closing force: EN 2-4
Door width : 1100mm
Door weight : 100 kg
Standard Arm & Slide Arm
ED 250–Electro mechanic operator
Closing force: EN 4-6
Door width: 1600mm
Door weight: 250 kg
Standard Arm & Slide Arm
ED100 ED250
Accessories
Radar movement detectors, pushbuttons, card readers, radio control, electronic access control systems, proximity type access control systems, electric strikes, safety sensors for protection of personnel in the opening and closing range, wireless activators
DORMA MANET-Sliding Architectural hardware for furniture
Sliding Door system Can be fixed with Glass wall portions
• Wall or glassed fixed • 100 KG Max leaf weight • Decorative Solution
Product Range - Room Divider
DORMA AGILE 150 Flexible and high-power
DORMA RSP 80 The approved sliding door system for highest loads
DORMA AGILE 50 Ultra-versatile lightweight
DORMA RS 120 The approved sliding door system for highest loads
DORMA AGILE 150 Flexible and high-power
DORMA AGILE 50 Ultra-versatile lightweight
• No Glass Preparation • 150 KG Max leaf weight • Celling or wall fixing • Stainless finish or stain aluminum
Finish
• No Glass Preparation • 50 KG Max leaf weight • Celling or wall fixing • Stain aluminum Finish
DORMA RSP 80 The approved sliding door system for highest loads
• For Glass or timber Sliding Solution • Max leaf weight 120 KG • Tracked predrilled for ease fixing
DORMA RS 120 The approved sliding door system for highest loads
• For Glass or Timber Sliding Solution • Max leaf weight 80 KG • Tracked predrilled for ease fixing
ES 200
• Sliding Door Operator Can Be Carry Weight up to 1000 KG • You Can Get a battery Back up • Available with different Heights 100,150,200 mm • The difference between each operator in weight and applications
Operator technical data
EL 301 & AL 401
DORMA sliding door operator
ES 200 Easy : 2 x 100 kg
ES 200 : 2 x 160kg
ES 200 2D : 2 x 130kg (escape)
ES 200 SST : 2x 100kg (breakout)
ES 400 : 1x 200 , 2x 125kg (hospital)
EL301 : 2 x 150kg (chain)
AL401 : 2 x 200kg (chain)
ST
TST
SST
RST
FFT
BST
DORMA complete door systems
Automatic telescoping sliding doors
Automatic sliding doors with breakout
Space-saver
Automatic folding doors
Curved sliding doors
Sliding doors
RST Space Saver The system provide max passage width because of Sliding and swing Motion
• Max door width 2000 mm • Max door height 2300 mm
RST
Motion Sensor
Rotating ceiling
Door drive Safety sensor Canopy
Disabled access push button
Key switch
Safety contact strip
Door leaves
Side wall
Core
Revolving door layout
Comfortline KTC 2 leaves – 3600, 4200,
4800, 5400 KTC 3,4 leaves – 3600, 4200,
4800, 5400, 6000, 6200 Varioline KTV Atrium –2000, 2200, 2400,
2600, 2800 (full glass door) KTV 3,4 – 2000 to 3800
(production in UAE)
KTV (Varioline) and KTC (Comfortline)
Manual - Manual Operation
Positioning - Manual push to start Servomatic - Door starts at low rpm Automatic I - Door activates as user approaches Automatic II - Door rotates at continuous rpm
Revolving door operation mode
A. Butt Hinges
• EN 1935 • CE mark • Fire Rated (45, 60, 90 min.) • 2 Ball Bearing & 4 All Bearing • 5 Knuckles • For wooden and metal doors • Up to 120 kg
• Different Dimensions • Different Sizes • Different Finishes • Square End and Round End • Removable Pin (RP) and Non
Removable Pin (NRP)
I. Hinges
• For Single Action Self-Closing Door • Different Sizes • Meets ANSI A156.17 • UL Listed • Stainless Steel • Fire rated
• For Double Action Self-Closing Door • Different Sizes • UL Listed • Meets ANSI A156.17 • Stainless Steel • Fire rated
B. Spring Hinge
C. LM Aluminum Hinges
• Door widths up to 1200 • Door weight up to 120kg • Easy to fix only 4 or 6
holes to drill • No visible screw
connections • Rugged and secure
attachment
D. Concealed hinge • For timber, steel or aluminum frames • For flush-fitting architectural structures • With a load capacity of 40 to 300 kg • With an opening angle of 180° • Different sizes • From high-quality interior doors to large, heavy-duty doors • Fire rated applications • Electrified Hinges • CE Mark
I. Mortise Locks European Range by Application
Timber Doors
200 SSS 304
NFR
200 CE SSS 304
FR
300 SSS 316
NFR
300 CE SSS 316
FR
Steel & Aluminum
Doors
700 NFR
700-F FR
500 NFR
500-F FR
• conforming to the technical requirements of DIN 18251 and EN 12209 • backset 55 mm, 60 mm, 65 mm, 70 mm, 80 mm • forend 20 mm, square / 20 mm, rounded / 24 mm, square / 24 mm, rounded • Satin stainless Dead bolt • Emergency Escape Locks • Narrow Stile Locks • Sliding Doors Lock
Euro profile Cylinder
Non Master key Master key
• 5-pin, 6-pin and 7-pin variants available. • Length: from 40 mm to 70 mm • Different Finishes • Different Functions (Double Profile, Half profile , Double with Thumb turn, Half with Thumb turn, and Toilet Cylinder) • 3 keys included
American Cylinder
Non Interchangeable Core Mortise Cylinders
Dummy and Thumb turn
Cylinders
Interchangeable Core Mortise Cylinders
Interchangeable Cores (SFIC)
• All Finishes Available • Master and Non master Key available
Door Closers
Rack and Pinion Concealed Cam
Action
TS 77 TS 72
TS 83
TS 73 EMF TS 99 EMF
TS 97
TS 93
TS 90
ITS 96
RTS 85
OVERHEAD DOOR CLOSER (EUROPEAN STANDARD)
Features TS 68 TS 71 TS 72 TS 73 V TS 77 TS 83
Spring strength EN 2 / 3 / 4 EN 3 / 4 EN 2 – 4 EN 2 – 4 EN 3, 4 EN 2 – 6, 7
External door opening No No No No No Yes
Fire & smoke check doors No No No Yes No Yes
Non handed Yes Yes Yes Yes Yes Yes
Arm type Slim line Standard Standard Standard Flat form
Standard Standard Flat form
Closing speed adjustment 180° – 15 °
15° – 0° 180° – 15 °
15° – 0° 180° – 15 °
15° – 0° 180° – 15 °
15° – 0° 180° – 20 °
20° – 0° By valve
Latching action By valve At arm At arm At arm By valve At arm
Back check No No No >At valve No >At valve
Delay action No No No No No Optional
Hold open Optional Optional Optional Optional Optional Optional
Certified to EN 1154 EN 1154 EN 1154 EN 1154
CE marked EN 1154 EN 1154
Weight 1.4 Kg 1.2 Kg 1.2 Kg 1.3 Kg 1.3 Kg 3.3 Kg