wheelhorse garden cart operating manual for 5, 10, 18 cubic foot models 803718r1

4
5.5 cu. ft. 5 cu. 10 cu. ft. cu. 18 cu. ft. cu. PRINTED IN NO. 803718Rl

Upload: kevins-small-engine-and-tractor-service

Post on 29-Mar-2015

55 views

Category:

Documents


1 download

DESCRIPTION

WheelHorse garden cart operating manual for 5, 10, 18 cubic foot models

TRANSCRIPT

Page 1: WheelHorse garden cart operating manual for 5, 10, 18 cubic foot models 803718R1

5.5 cu. ft. 5 cu.

10 cu. ft. cu.

18 cu. ft. cu.

PRINTED IN NO. 803718Rl

Page 2: WheelHorse garden cart operating manual for 5, 10, 18 cubic foot models 803718R1

A Vehicle Identification Number identifies your Wheel Horse attachment. This number should be referred to when with your dealer or the parts, or

is removed be reClloc:ea

5.5 cu. ft. cu. Place the axle

Item 2) between the and insert the axle

On each end of the axle install the in the order listed: one washer tire another washer a cotter hub Be sure the valve and grease the are to the outside.

Install rod of latch of frame

bolt (11) down Slide

purpose pressure gun grease. 10 cu. ft. cu. DUMP CART

Place axle holders (l With the

that the of the fits between the axle holders. holders around so that the correct

obtained. Secure the axle holders to the 6 x 1 bolts and nuts, but do not

5.5 cu. ft.

on

5 cu.

Slide the axle drawbar install the washer

the axle holders and each end of axle

in the order listed: one and tire another washer

and hub (11). The washers are their side from the wheel Be sure the valve

on the wheel are to the outside. Now the nuts and bolts that secure the axle holders to the bed.

Install the drawbar bed (1) x and nuts.

gun grease.

18 cu. ft. cu. DUMP CART

wheel purpose pressure

Position the axle of the drawbar between the axle on the bed

(l) and install the axle Place a wheel and tire on each end of the and install cotter and hub Be sure the valve and grease

on the to the outside.

Secure each side to the bed (1) with two 6 x 1 % flat washers and two 6 nuts. Use a flat washer under each bolt head and nut. Attach front and rear to the side with four 16 x flat washers and 6 nuts. A flat washer should under each bolt bolts and nuts so that the front and rear gates are free to open.

a 6 x 1 bolt and nut, secure the front to the bed (1). The rear latch

(1 is installed the x 1 bolt and bolt

from the washer on bolt and then thread the bolt.

purpose pressure gun grease.

Cart

Page 3: WheelHorse garden cart operating manual for 5, 10, 18 cubic foot models 803718R1

10 cu. ft. cu. Cart A,"sel1nbllv

18 ft. cu. Cart Assel1nblly

2

Page 4: WheelHorse garden cart operating manual for 5, 10, 18 cubic foot models 803718R1

carts must be limited to the below for proper vehicle

mowers ........ . lawn tractors ..

8, C, & E-Series

0-250

50 Ibs. 50 Ibs.

275 Ibs. 350 Ibs. 500 Ibs.

5.5 cu. ft. 5 cu. DUMP CART

the box may be so that the trailer will not the latch bracket on the box

from the tractor latch rod and

backwards until tractor can then

the

tongue hole in

hole in the tongue for this purpose.

and

at a

manual for form below

to the address below.

Enter number shown on your attachment:

I have enclosed a check or money order for $1.00 for each manual

10 and 18 cu. ft. The

seat

constructed

ca,nolp.t,!'>lv empty

cable arrangement can be and connected to the latch actuation of the latch from the

line or other weather resistant and route it to a convenient

Cable or can be of rod as a handle.

cart after each use with a hose. An automotive may also if desired. Touch up surfaces or or grease to bare metal to cans of Wheel Horse red and touch are available from your Authorized Dealer.

After lubricate machine oil check that all Each wheel on the cart has a zerk sure grease gun. lubricate the wheels

pressure gun grease at 10

tire pressure Store the

it if stored end to

Wheel Horse attachment can be obtained it, with a check or money

Nom ..

Add,,,,.

than one attachment, you own. There­

your attachments one

MAILING LABel - PLEASE PRINT CLEARLY