waterproof bluetooth hema speaker battery replacement · waterproof bluetooth hema speaker battery...
TRANSCRIPT
Waterproof Bluetooth HEMA speaker BatteryReplacement
We will show how to replace the battery of the HEMA waterproof bluetooth speaker.
Written By: Silke de Jong
Waterproof Bluetooth HEMA speaker Bat… Draft: 2019-05-13Guide ID: 78699 -
This document was generated on 2020-11-28 05:40:14 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5
INTRODUCTION
This guide will tell you how to replace the battery of the bluetooth speaker. It's an easy guide,however you have to solder the wires. The guide can also easily be used for replacing other parts ofthe speaker.
TOOLS:Soldering Iron (1)Super Glue (1)Phillips PH000 Screwdriver (1)
PARTS:3.7v 400 mAh Lithium Battery (1)
Waterproof Bluetooth HEMA speaker Bat… Draft: 2019-05-13Guide ID: 78699 -
This document was generated on 2020-11-28 05:40:14 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5
Step 1 — Battery
Turn the device upside down.
Step 2
Pull off the rubber suction cup.
Waterproof Bluetooth HEMA speaker Bat… Draft: 2019-05-13Guide ID: 78699 -
This document was generated on 2020-11-28 05:40:14 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5
Step 3
Unscrew the four 6mm round Phillips#000 head screws on the bottom ofthe product.
Step 4
Remove the rear clamshell.
Separate the battery from the speaker by pulling gently. The foam adhesive will release.
Waterproof Bluetooth HEMA speaker Bat… Draft: 2019-05-13Guide ID: 78699 -
This document was generated on 2020-11-28 05:40:14 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5
To reassemble your device, follow these instructions in reverse order.
Step 5
Unscrew the four 4 mm roundPhillips #000 screws that keep thecircuit board in place.
Take out the circuit board.
Step 6
Detach the battery by gentlyunsoldering the wires with asoldering iron. Also look at thecolors of the wires,
Take note of the location thewires were attached and thenegative and positive side.
Take a new 3,7V 400 mA Lithiumbattery and solder it to the circuitboard where the old battery wasattached.
Waterproof Bluetooth HEMA speaker Bat… Draft: 2019-05-13Guide ID: 78699 -
This document was generated on 2020-11-28 05:40:14 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5