Double (70 mil) or Quad (50 mil) Density Grid 4-Wire Measurement Long Pin Fixtures 95 mm / 3,75” Test Area up to 406 mm x 325 mm / 16.0” x 12.8”

A3030 Universal Grid Test System

Data Preparation External generation with established fixture building program (e.g. ADAM II)

Fault Location Fault location and verification is done in CAR II or on an atg flying prober

Option Retractable guide rails 4-Wire Measurement 10 mΩ to 100 Ω

Power supply 400 V, 50 / 60 Hz, 3500 VACompressed air 6-8 bar, about 90 psi (dried and filtered)Temperature 18 °C - 27 °C (64 °F - 77 °F)Relative humidity 40 % - 60 % (10 MOhm) 45 % - 55 % (100 MOhm)Machine weight About 2045 kg / 4508 lbs

All information subject to change without notice! May 2015

Test Field Size

Maximum (X x Y) 406 mm x 325 mm / 16.0” x 12.8” DD (70 mil) or QD (50 mil)

ValuGrid® long pin fixture, 95 mm / 3,75”, both sides

Board Handling

Minimum board size (X x Y) 50 mm x 50 mm / 2.0” x 2.0”Maximum board size (X x Y) 460 mm x 335 mm / 18.1” x 13.2”Maximum board thickness 4 mmMinimum board thickness - manual testing 0.1 mm / 0.0039”- automatic testing 0.6 mm / 0.023”

Test Points

QD 16.0” x 12.8” 81.920 test points with 40.960 test channels per side

Test Parameters

Test voltage 40 V - 250 V DCContinuity threshold 10 Ω - 10 kΩIsolation threshold 100 kΩ - 100 MΩEmbedded Resistor Measurement 1 Ω to 10 kΩ

A3030 Technical SpecificationsUniversal Grid Test System

Front View Side View

atg Luther & Maelzer GmbHZum Schlag 3 • 97877 Wertheim • GermanyPhone +49 9342 291 0 • Fax +49 9342 395 10 sales@atg-LM.com • www.atg-LM.com

atg Luther & Maelzer GmbHHagenburger Strasse 54 • 31515 Wunstorf • GermanyPhone +49 5031 174 0 • Fax +49 5031 174 109 sales@atg-LM.com • www.atg-LM.com