1. Created by: Luis Rizki Saves Renyaan Ahmad Harianto NA Fithrah Idris MutmainnahAsheri Planner Machine

2. Planner Machine The planner machine is used for smoothing the wood surface. Most of these machine are made of iron.This machine is shaped like square on the bottom and shaped like rectangle at the top. This machine is 60 cm in length and 150 cm in width. most of these machine are gray.This machine is connected by wire to the power source. 3. Angle adjustment lever Wood side retaining board Wooden brace On-Off button Front table Back table Table heigh adjustment lever 4. parts On off button is used for turning on or turning off the machine. Its made off plastic.its shaped like a circle.The diameter of this button is 2 cm. the color of the on button is green and the color of off button is red.The buttons are at the front and outside of the machine.The buttons are fixed to the machine 5. parts Right Angle Adjustment Lever is used for setting the right angle of the wood retaining board in the straight way. Its made of iron Its shaped like rectangle but in the tip is shaped like circle This tool is 15 cm in length The color of this tool is grey This tool is on the top of the machine and in the back of the wood retaining board, its hard and detached from the machine 6. parts Wood Retaining Board is used for holding wood in the right angle. Its made of iron, and shaped like rectangle.This tool is 60 cm in length and 15 cm in width. the color of this tool is dark brown. The position of this tool is on the top of the machine.This tool is thick and the edge of this board is straigh 7. parts Wooden Brace is used for holding wood when flatting process.The wooden brace will hold the wood so that the wood will move slowly. Its made of the iron. Its shaped like quarter circle.This tool is 20 cm in length and width.The color of this tool is orange.This tool is on the top of the drive wheel.This tool is detached from machine.This tool is hard 8. parts DriveWheel is used for helping us to move the wood when the wood is in the smoothing procces.The drive wheel will forward the wood slowly. Its also made of iron. Its shaped like cylinder. Dimension of this wheel is about 30 cm long and the diameter is about 7 cm.The color of the wheel is brown.The wheel is in the inside of the machine, and in the middle between two miser knife. The wheel is fixed to the machine.The interior of this tool is hollow. 9. parts Miser knife is used for smoothing the wood side. Its made of iron. Its shaped like rectangle.This knife is 5 cm high and 20 cm long.The color of the knife is grey. The knife is on the top of the machine and in the middle of the table.The knife is fixed to the table of the machine 10. parts Table height adjustment lever is used to setting the table height according our comfort position. It made of iron but the grip is made of rubber. Its shaped like cylinder. this tool is 30 cm in length.The color of this tool is grey but the color of the grip is black.This tool is outside of the machine, under the back table.This tool is fitted in to the machine.This tool is hard 11. parts BackTable and FrontTable Back table is use to put the wood before processed. Its made of the triplex at the top and iron on the side. Its shaped like rectangle.This table is 100 cm in length and 40 cm in width.The color of the table surface is dark brown and the color of the margin is grey.This table is in the back of the top of the machine. This table is fitted over the machineThe table is thick and the edge of this table is straight Front table is same like back table but its in the front of the top of the machine 12. How to Use This Machine? Put the wood here Setting the right angle here Press the ON button And then pull the wood crossing the miser knife untill the miser knife flatting all of the wood surface 13. end of slide show thank you