tri-d25 final label

TRI-D25 Version: 1 of 4

APVMA File No. 27/02/2007

Label Booklet

CAUTION KEEP OUT OF REACH OF CHILDREN

READ SAFETY DIRECTIONS BEFORE OPENING OR USING

Tri-D25 WP BIOLOGICAL FUNGICIDE

ACTIVE CONSTITUENTS: Trichoderma koningii 3 x 10

7/g

Trichoderma harzianum 2 x 107/g

(5 x 107 spores/g product, derived from the fermentation of Trichoderma spp.)

For the control of Grey Mould (Botrytis cinerea) in grapes.

IMPORTANT: Read the attached label before use.

1 Kg

Manufactured by: JH Biotech, Inc. P.O. Box 3538, Ventura, CA 93006, USA.

Distributed by: Zadco For Quality Gro PTY LTD. ABN 57 080 7 59 084 9/9A Foundry Road, Seven Hills, NSW 2147 Sydney-Australia

APVMA Approval No.:

Item number



Label Booklet

GENERAL INSTRUCTIONS

APPLICATION DO NOT apply as a concentrate spray.

CLEANING EQUIPMENT BEFORE APPLICATION Tri-D25 contains live fungal spores and therefore has specific requirements in order that the product is properly activated, successfully establish and help to control disease. Spraying equipment (and all other application equipment, especially tank filters) should be thoroughly cleaned to remove all chemical residues, particularly fungicides, by soaking the spray tank and filters in a urea solution. Use 0.5-1.0 Kg urea (or bicarbonate of soda) per 100 L of water. Ensure the tank is filled and re-circulating contents for several minutes, before leaving to soak overnight. The following day, the spray equipment should be flushed and rinsed thoroughly with fresh water.

PREPARING SPRAY The required amount of Tri-D25 MUST be soaked in a clean container of clean luke-warm (20

0-30

0

Celcius) water for 4-6 hours to successfully activate before use.

COMPATABILITY/TANK MIXING When spraying crops directly, apply as a dilute spray only. DO NOT mix with any other chemicals, including fungicides, insecticides or adjuvants. DO NOT apply Tri-D25 within 10 days of any fungicide spray (before or after). Spray Tri-D25 always late afternoon or evening time to allow for better proliferation and multiplication of the beneficial fungi to occur away from the harsh sunlight during the day.

PROTECTION OF WILDLIFE, FISH, CRUSTACEANS AND ENVIRONMENT DO NOT contaminate dams, waterways or drains with this product or used containers.

STORAGE AND DISPOSAL Store in the closed, original container in a cool, well ventilated area. DO NOT store for prolonged periods in direct sunlight or in closed rooms with temperatures exceeding 25 degrees centigrade. Add rinsings to spray tank. Puncture and bury empty containers in a local authority landfill. If no landfill is available, bury the containers below 500 mm in a disposal pit specifically marked and set up for this purpose clear of waterways, vegetation and roots. Empty containers and product should not be burnt.

SAFETY DIRECTIONS Avoid contact with eyes, skin and open wounds. After use and before eating, drinking or

smoking, wash hands, arms and face thoroughly with soap and water.

FIRST AID If poisoning occurs, contact a doctor or Poisons Information Centre. Phone 131 126.

MATERIAL SAFETY DATA SHEET: If additional hazard information is required refer to the Material Safety Data Sheet. For a copy phone 02 9838 9111 or visit our website at www.zadco.com.au



Label Booklet

MANUFACTURER’S WARRANTY AND EXCLUSION OF LIABILITY Zadco For Quality Gro PTY LTD and JH Biotech Inc have no control over storage, handling and manner of use of this product. Where this material is not stored, handled or used correctly and in accordance with directions, no express or implied representations or warranties concerning this product (other than non-excludable statutory warranties) will apply. Zadco For Quality Gro PTY LTD and JH Biotech Inc accepts no liability for any loss or damage arising from incorrect storage, handling or use. Tri-D25 is supplied as a high-grade material and is suitable for the purpose for which it is expressly intended and must be used in strict accordance with the conditions for use. Manufacturer or seller makes no warranty, whether expressed or implied, concerning the use of this product other than for the purposes indicated on the label. Neither manufacturer nor seller shall be liable for any injury or damage caused by this product due to misuse, mishandling or any application not specifically described on the label.

® Registered Trademark of Zadco For Quality Gro PTY LTD

∗ Registered Trademark

Batch No. Date of Manufacture

Bar Code

THIS PRODUCT IS NOT CONSIDERED TO BE A

DANGEROUS GOOD UNDER THE AUSTRALIAN

CODE FOR THE TRANSPORT OF DANGEROUS

GOODS BY ROAD OR RAIL

In a transport emergency dial 000, Police or Fire Brigade.

For specialist advice in an emergency only, call 1800 033 111

(24 hours).



Label Booklet

DIRECTIONS FOR USE

Crop Disease

Controlled

State Rate Critical Comments

Grapes Grey Mould

(Bunch Rot)

Botrytis cinerea

All States Dilute

spraying

100 g per

100 L of

water (Not

less than 1

Kg/ha)

Carefully read comments in Cleaning Equipment

Before Application and Preparing Spray sections.

Apply as a dilute spray only. DO NOT mix with any other chemicals, including fungicides, insecticides or adjuvants. DO NOT apply Tri-D25 within 10 days of any fungicide spray (before or after).

Applications are best made early-mid evening ideally when free moisture such as dew or even light rain occurs. Ensure bunches are targeted when spraying. DO NOT apply when temperatures are less than 18

0C

or greater than 350C. Ensure continuous agitation of

the tank mixture for even distribution of spores whilst spraying.

Tri-D25 can be applied at any time from 80% cap fall to 1-2 days before harvest. However, best results have occurred when used as part of an integrated approach to managing bunch rot, during periods of high moisture, especially late in the season. After veraison, during periods of extended moisture and disease pressure, the applications of Tri-D25 should be made at 7-14 day interval or as needed.

NOT TO BE USED FOR ANY PURPOSE, OR IN ANY MANNER, CONTRARY TO THIS

LABEL UNLESS AUTHORISED UNDER APPROPRIATE LEGISLATION.

WITHHOLDING PERIOD: NOT REQUIRED WHEN USED AS DIRECTED

tri-d25 final label

Documents