transferencia calor y masa
DESCRIPTION
teoría primer capitulo transferenciaTRANSCRIPT
![Page 1: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/1.jpg)
Conservation of Energy
Chapter One Section 1.3
![Page 2: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/2.jpg)
Alternative Formulations
• Alternative Formulations Time Basis:
At an instant or Over a time interval
Type of System: Control volume Control surface
• An important tool in heat transfer analysis, often providing the basis for determining the temperature of a system.
CONSERVATION OF ENERGY (FIRST LAW OF THERMODYNAMICS)
![Page 3: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/3.jpg)
• At an Instant of Time:
Note representation of system by a control surface (dashed line) at the boundaries.
Surface Phenomena , energy transfer across the control
su
: rate of thermal and/or mechanical
due to heat transfer, fluid flow and/or worrfa k ic nteract
io .e nsin outE E
g g
Volumetric Phenomena : rate of due to conversion from another enegy form
(e.g., electrical, nuclear, or chemical); energy conversion proc
thermal ener
ess occurs w
gy generatio
ithin the sy e
n
m.
stgE
g
energy storage in the system: rate of change . of stEg
Conservation of Energy
in out g stdEstdtE E E E− + = ≡
g g g g(1.11c)
Each term has units of J/s or W.
APPLICATION TO A CONTROL VOLUME
• Over a Time Interval
Each term has units of J. in out g stE E E E− + =Δ (1.11b)
CV at an Instant and over a Time Interval
![Page 4: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/4.jpg)
At an instant
tdUq W dt− =
g
• Special Cases (Linkages to Thermodynamics) (i) Transient Process for a Closed System of Mass (M) Assuming Heat Transfer to the System (Inflow) and Work Done by the System (Outflow).
Over a time interval totstQ EW− = Δ
(1.11a)
Closed System
For negligible changes in potential or kinetic energy
tQ W U− = Δ
Internal thermal energy
![Page 5: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/5.jpg)
Example 1.3: Application to thermal response of a conductor with Ohmic heating (generation):
• Involves change in thermal energy and for an incompressible substance.
tdU dTMcdt dt
=
• Heat transfer is from the conductor (negative ) q
• Generation may be viewed as electrical work done on the system (negative ) Wg
Example 1.3
![Page 6: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/6.jpg)
Example 1.4: Application to isothermal solid-liquid phase change in a container:
Latent Heat of Fusion
t 1at sfU U MΔ = Δ = h
Example 1.4
![Page 7: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/7.jpg)
(ii) Steady State for Flow through an Open System without Phase Change or Generation:
( ) flow o w rkpv →•( ) enthalp ytu pv i+ ≡ →•
( )ideal gas constant specific h For an w eatith :
in out p in outi i c T T− = −
•
( )( ) ( )
For an :incompressible liquid
0in out in out
in out
u u c T T
pv pv
− = −
− ≈
•
( ) ( )( ) ( )
2 202 2
0
For systems with significant heat transfer:
− ≈
− ≈
in
in
outV V
gz gz out
•
At an Instant of Time: 202t
out
m u pv V gz W⎛ ⎞
− + + + − =⎜ ⎟⎝ ⎠
••22t
inm u pv V gz q⎛ ⎞+ + + +⎜ ⎟⎝ ⎠
•(1.11d)
Open System
![Page 8: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/8.jpg)
Surface Energy Balance
A special case for which no volume or mass is encompassed by the control surface. Conservation Energy (Instant in Time):
0outinE E− =g g
(1.12)
• Applies for steady-state and transient conditions.
Consider surface of wall with heat transfer by conduction, convection and radiation.
0cond conv radq q qʹ′ʹ′ ʹ′ʹ′ ʹ′ʹ′− − =
( ) ( )4 41 22 2 2 0sur
T Tk h T T T TL
ε σ∞−
− − − − =
• With no mass and volume, energy storage and generation are not pertinent to the energy balance, even if they occur in the medium bounded by the surface.
THE SURFACE ENERGY BALANCE
![Page 9: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/9.jpg)
Methodology
• On a schematic of the system, represent the control surface by
dashed line(s).
• Choose the appropriate time basis.
• Identify relevant energy transport, generation and/or storage terms by labeled arrows on the schematic.
• Write the governing form of the Conservation of Energy requirement.
• Substitute appropriate expressions for terms of the energy equation.
• Solve for the unknown quantity.
METHODOLOGY OF FIRST LAW ANALYSIS
![Page 10: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/10.jpg)
Problem 1.43: Thermal processing of silicon wafers in a two-zone furnace. Determine (a) the initial rate of change of the wafer temperature and (b) the steady-state temperature.
Problem: Silicon Wafer
KNOWN: Silicon wafer positioned in furnace with top and bottom surfaces exposed to hot and cool zones, respectively.
FIND: (a) Initial rate of change of the wafer temperature from a value of w,iT 300 K,= and (b) steady-state temperature. Is convection significant? Sketch the variation of wafer temperature with vertical distance.
SCHEMATIC:
•
![Page 11: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/11.jpg)
Problem: Silicon Wafer (cont.)
ASSUMPTIONS: (1) Wafer temperature is uniform, (2) Hot and cool zones have uniform temperatures, (3) Radiation exchange is between small surface (wafer) and large enclosure (chamber, hot or cold zone), and (4) Negligible heat losses from wafer to pin holder.
ANALYSIS: The energy balance on the wafer includes convection from the upper (u) and lower (l) surfaces with the ambient gas, radiation exchange with the hot- and cool-zone and an energy storage term for the transient condition. Hence, from Eq. (1.11c),
in out stE E E− =g g g
or, per unit surface area
, , , ,w
rad h rad c cv u cv ld T
q q q q cddt
ρʹ′ʹ′ ʹ′ʹ′ ʹ′ʹ′ ʹ′ʹ′+ − − =
( ) ( ) ( ) ( )4 4 4 4,,
ww sur c w u w l wsur h
d TT T T T h T T h T T cd
dtεσ εσ ρ∞ ∞− + − − − − − =
(a) For the initial condition, the time rate of change of the wafer temperature is determined using the foregoing energy balance with w w,iT T 300 K,= =
( ) ( )8 2 4 4 4 8 2 4 4 4 440.65 5.67 10 W /m K 1500 300 K 0.65 5.67 10 W /m K 330 300 K− −× × ⋅ − + × × ⋅ −
( ) ( )2 28W/m K 300 700 K 4W/m K 300 700 K− ⋅ − − ⋅ − =
32700kg /m 875J / kg K× ⋅ ( )w i0.00078 m dT / dt×
( )w idT / dt 104 K / s=
![Page 12: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/12.jpg)
Problem: Silicon Wafer (cont.)
(b) For the steady-state condition, the energy storage term is zero, and the energy balance can be solved for the steady-state wafer temperature, w w,ssT T .=
( ) ( )4 4 4 4 4 4w,ss w,ss0.65 1500 T K 0.65 330 T Kσ σ− + −
( ) ( )2 2w,ss w,ss8W/m K T 700 K 4W/m K T 700 K 0− ⋅ − − ⋅ − =
w,ssT 1251 K=
To assess the relative importance of convection, solve the energy balances assuming no convection. With ( )w w,ssid T / dt 101 K / s and T 1262 K.= = , we conclude that the radiation exchange processes control the initial rate of change and the steady-state temperature.
If the wafer were elevated above the present operating position, its temperature would increase, since the lower surface would begin to experience radiant exchange with progressively more of the hot zone. Conversely, by lowering the wafer, the upper surface would experience less radiant exchange with the hot zone, and its temperature would decrease. The temperature-distance relation might appear as shown in the sketch.
![Page 13: transferencia calor y masa](https://reader034.vdocuments.us/reader034/viewer/2022042423/5695d22d1a28ab9b0299638e/html5/thumbnails/13.jpg)
Problem Cooling of Spherical Canister
Problem 1.48: Cooling of spherical canister used to store reacting chemicals. Determine (a) the initial rate of change of the canister temperature, (b) the steady-state temperature, and (c) the effect of convection on the steady-state temperature.
KNOWN: Inner surface heating and new environmental conditions associated with a spherical shell of prescribed dimensions and material.
FIND: (a) Governing equation for variation of wall temperature with time and the initial rate of change, (b) Steady-state wall temperature and, (c) Effect of convection coefficient on canister temperature.
535 J/kg·K