SKU# 4704 | MFG# AV-1006

TOOLS REQUIRED:-T25 TORX-T30 TORX-CLEAN EMPTY BUCKET-JACK-JACKSTANDS

R S 3 M E S H S T Y L E G R I L L E : 8 V A U D I A 3 / S 3S K U # 4 7 0 4 M F G # A V - 1 0 0 6

INSTRUCTIONS ARE ALSO AVAILABLE ONLINE FOR A MORE ENHANCED VIEWING.PLEASE VISIT WWW.USPMOTORSPORTS.COM AND SEARCH SKU# 4704

1919 NW 40th COURT, POMPANO BEACH, FL 33064WWW.USPMOTORSPORTS.COM

2

INSTALL INSTRUCTIONS RS3 MESH STYLE GRILLE: 8V AUDI A3/S3

SKU# 4704 | MFG# AV-1006

6. Disconnect bumper wire harness located under driver’s side head-light. Press in red clip to unlock, then unplug.

7. Using a clean empty bucket, place below washer fluid reservoir (located just behind passenger side headlight). Disconnect washer fluid hose by pressing in on blue sides of clip. Allow to drain into bucket, then remove hose from securing clips.

8. Remove 3 T-30 torx screws.

1. Lift car and secure using jackstands (front wheels do not need to be removed).

2. Remove 5 T-25 torx screws from each fender well lining.

3. Remove 3 T-30 torx screws from inside bumper on each side.

4. Remove 16 torx screws from under carriage.

5. Push in clips, while pulling down front portion of splash guard. Then remove lower splash guard and set aside.

3

INSTALL INSTRUCTIONS RS3 MESH STYLE GRILLE: 8V AUDI A3/S3

SKU# 4704 | MFG# AV-1006

9. Carefully remove bumper and place onto a surface which will not scratch the bumper finish.

10a. If car is equipped with park assist, unplug sensors. Then remove wire har-ness from securing clips in grill.

11a. Remove 6 torx screws from OEM grille.

10b. Remove washer fluid hose from securing clips. Remove park assist sen-sors by pushing in from the front of the sensors while simultaneously pushing outwards on the clips from the rear as shown.

11b. Remove 3 screws from lower grille.

12. Remove lower rub guard, by disengaging 13 clips as shown.

13a. Remove OEM grille by dis-engaging clips at top corners. Then pull down on lower grille section to slide out OEM grille which is wedged between lower grille and bumper.

4

INSTALL INSTRUCTIONS RS3 MESH STYLE GRILLE: 8V AUDI A3/S3

SKU# 4704 | MFG# AV-1006

13b. While pulling down on the lower grille (at arrows), slide in the new grille in front of lower grille. Then push top portion of new grille into place, and secure all clips.

14. Secure new grill with 6 original torx screws.

15. If car is equipped with park assist, reinsert sensors into holes until clipped into place.

16. Secure harness & washer fluid hose with original clips as shown.

17. Gently push new audi rings into grill, paying extra detail not to break any clips. Once rings are flush with front grill, make sure tabs are all securing the rings at locations shown from the rear.

18. Reinstall the bumper and splashguards properly in reverse order using origi-nal fasteners. Plug in all connections which were detached and refill washer fluid reservoir.

Some modification may be required for parking sensors to function properly.

Enjoy your new grille!