three-phase to single-phase cycloconverter
TRANSCRIPT
-
8/20/2019 Three-Phase to Single-Phase Cycloconverter
1/9
THREE-PHASE TO SINGLE-PHASE CYCLOCONVERTER
-
8/20/2019 Three-Phase to Single-Phase Cycloconverter
2/9
-A three-phase to single phasecycloconverter is a type of cycloconverterthat converts a three-phase voltage system(AC Supply) to a single-phase system (ACsupply).
-
8/20/2019 Three-Phase to Single-Phase Cycloconverter
3/9
-Has a constant input frequency and a
variable output frequency.
- It is a step do n cycloconverter thereforethe output frequency is less than the inputfrequency voltage. (f o ! f i)
-
8/20/2019 Three-Phase to Single-Phase Cycloconverter
4/9
2 Types of Three phase toSing e Phase
Cy! o!on"erter
-
8/20/2019 Three-Phase to Single-Phase Cycloconverter
5/9
2 Types of Three phase to Sing e PhaseCy! o!on"erter
-
8/20/2019 Three-Phase to Single-Phase Cycloconverter
6/9
- "hree-#hase to Single-#hase Cycloconverter can bea half ave or full- ave (bridge). $i%e the singlephase to single phase& a recti'ed voltage is alsoapplied to the load terminals by each group ofthyristors.
- uring positive half cycle of the input& conduction of
the positive group thyristors is controlled and duringnegative half-cycle& conduction of negative group ofthyristors is controlled in order to produce an outputvoltage at desired frequency.
-
8/20/2019 Three-Phase to Single-Phase Cycloconverter
7/9
- "herefore& the cyclo-converter can operate in fourquadrants& i.e.& recti'cation modes of ( *& i) and (-*& -i) and inversion modes of ( *& -i) and (-*& i).
- In a bridge type of cyclo-converter& both positiveand negative converters can generate voltages at
either polarity& but negative converter only suppliesnegative current hile positive converter supplypositive current.
-
8/20/2019 Three-Phase to Single-Phase Cycloconverter
8/9
"he above 'gure sho s the conversion of threephase supply at one frequency to single phasesupply of lo er frequency. In this& the 'ring angleto a positive group of thyristors is variedprogressively to produce single phase outputvoltage.
At point +& the 'ring angle is , degrees and it isreduced till point S here it is ero. Again from point " to
/& the delay angle is progressively increased.
"his varied triggering signals to the thyristors& varies itsconduction time periods and hence the frequency of theoutput voltage.
-
8/20/2019 Three-Phase to Single-Phase Cycloconverter
9/9
"he polarity of the current determines if the positive ornegative converter should be supplying po er to the load.Conventionally& the 'ring angle for the positive converteris named a#& and that of the negative converter is nameda0.
- 1hen the polarity of the current changes& the converterpreviously supplying the current is disabled and theother one is enabled.
- "he load al ays requires the fundamental voltage to becontinuous. "herefore& during the current polarityreversal& the average voltage supplied by both of theconverters should be equal.
- 2ther ise& s itching from one converter to the otherone ould cause an undesirable voltage 3ump. "oprevent this problem& the converters are forced toproduce the same average voltage at all times.