the pennﬁeld cottage - shed nation · that you will need to snip the dripedge to allow bend dorqj...

Little Cottage Co.PO Box 455

Berlin OH 44610330-893-4212

© 2007 Little Cottage Co.

Cordless drill (12V or higher)#2 square drive bitHammer6’ step ladderTape measureSquare utility knife w/ blade & hook blade

••••••

The Pennfield Cottage

Tools Needed:

This page intentionally left blank.

Construction Manual © 2007 Little Cottage Co. Page 1


1

5 6

toenail into 4x4 as shown.

underlying 4x4 on a 48” center.

3

2

4

7 8

Thank you for purchasing from Little Cottage Co!

1”

sheeting.



13 14

15 16

9 10

11 12

Locate the strip of siding to be attached below the

secure.



1817

24

19

21 22

23

20

Again, locate the strip of siding to be attached below Locate the two sections of the left gable end.

24

With the ends secure, apply pressure (inward or

sides of studs.



29 30

31 32

25 26

27

Locate the two sections of the left gable end, noting

opening and secure.

28



3433

40

35

37

34

39

36

Then secure the gable and lower wall panel at the

braces on both sides and along the top.

headed screw on both sides of splice while end blocks

38



45 46

47 48

41 42

43 44

set truss in place. screws through the sides and one through the top.

secure sheeting to truss.

Plywood strip will support porch rafters



5049

56

51

53 54

55

52

With the roof sheeting in place, proceed to the porch.

the porch railing.

Post

railing



61 62

63 64

57 58

59 60

Next, set the right railing structure on the porch decking post. Then set the left railing structure in place and

structure and place atop the porch posts.top of post.

Locate the porch gable and set in place.

screws.



6665

72

67

69 70

71

68

Use an angle and apply pressure to siding splice.

With rafters in place, next install porch roof sheeting

porch.

inches.



77 78

79 80

73 74

75 76

that you will need to snip the dripedge to allow bend Once dripedge is in place, snip the sharp edges off at both corners of the porch.

Per the instructions on the shingle package, begin shingling roof.



8281

88

83

85 86

87

84

screws per side.

black headed screws at each corner.

with your kit.



93 94

95 96

89 90

91 92

screws upward through the sheeting and into the



9897

99 100

101 102

103 104

Measure and snap a chalk line along sheeting for the the end along roof line.

instructions.



Then secure.

105 106

107 108

109 110

111 112

in place.



116

117 118

119 120

113 114

115

Locate and set the adult door spacer in place.

With the lower section of door in place, set the adult door spacer as shown.

headed screws.

On the inside of door, slide pin handle through hole,



121 122

123 124

125 126

127 128

headed screws.enough to hold latch in place but not too tight as to

Attach outside pulls as shown.

Hold shutter in place, centering it within the height of Hold opposite shutter in place, center it within height



129

screws along top of inner back side.

the pennﬁeld cottage - shed nation · that you will need to snip the dripedge to allow bend dorqj...

Documents