the beatles rock band hofner bass directional pad replacement · the beatles rock band hofner bass...
TRANSCRIPT
-
The Beatles Rock Band Hofner BassDirectional Pad Replacement
This guide will demonstrate how to replace the directional pad button on the guitar.
Written By: Jacob
The Beatles Rock Band Hofner Bass Directional Pad Replacement
iFixit CC BY-NC-SA www.iFixit.com Page 1 of 5
-
INTRODUCTION
This guide is for how to replace the directional pad on the Rock Band Beatles Hofner Bass.
TOOLS:JIS Driver Set (1)
The Beatles Rock Band Hofner Bass Directional Pad Replacement
iFixit CC BY-NC-SA www.iFixit.com Page 2 of 5
http:/IF145-115-1
-
Step 1 Back Plate
Flip the bass onto its backside, sothat the strummer is facing the tableand the battery compartment isfacing you.
Use a J1 Phillips head screwdriverto remove ten 5mm short screws.
Use a J1 Phillips head screwdriverto remove four 5mm long screws.
Step 2
Flip the bass to the front, with thestrummer and fret buttons facingyou.
Use a J1 Phillips head screwdriverto remove two 10mm silver, shortscrews.
The Beatles Rock Band Hofner Bass Directional Pad Replacement
iFixit CC BY-NC-SA www.iFixit.com Page 3 of 5
-
Step 3
Flip the bass on its back again, so that the strummer is facing down and the battery compartmentis facing you.
Pull off the back whole panel so that the bass is now open.
Step 4 Directional Pad
Use a J1 Phillips screwdriver to remove the six screws 10mm around the brown button cover.
The Beatles Rock Band Hofner Bass Directional Pad Replacement
iFixit CC BY-NC-SA www.iFixit.com Page 4 of 5
-
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2017-06-16 07:24:13 PM.
Step 5
Remove the directional pad button,
The Beatles Rock Band Hofner Bass Directional Pad Replacement
iFixit CC BY-NC-SA www.iFixit.com Page 5 of 5
The Beatles Rock Band Hofner Bass Directional Pad ReplacementWritten By: JacobINTRODUCTION
TOOLS:Step 1 Back PlateStep 2Step 3Step 4 Directional PadStep 5