sulfide remobilisation from sulfide ore at high
DESCRIPTION
SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGHTEMPERATURES AND DIFFERENTIAL STRESSES:AN EXPERIMENTAL APPROACHTRANSCRIPT
![Page 1: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/1.jpg)
SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGHTEMPERATURES AND DIFFERENTIAL STRESSES:AN EXPERIMENTAL APPROACH
![Page 2: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/2.jpg)
INTRODUCTION:
Remobilisation is the process of ore components being transported from pre-existing ore bodies (Mookherjee, 1976;Marshall et al., 2000a, b).
Radical modification of primary ore bodies due to mechanical and chemical remobilization (Mookherjee, 1976; Marshall & Gilligan, 1987). Marshall and Gilligan (1993) classified remobilisation into internal and external cases.
Previous experiments commonly separated mechanical from chemical remobilisation, and hence the simulations did not address the interactions between the two factors.
![Page 3: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/3.jpg)
STARTING MATERIAL:
Collected from -707 m level in the main ore zone of the Hongtoushan deposit, Liaoning Province, NE China.
It is a volcanic-hosted massive sulfide deposit metamorphosed at upper amphibolite facies at temperatures between 600 and 650°C during 3.0–2.8 Ga (Zhang et al., 1984; Liu et al., 1994).
The ore consists of pyrite (32 vol.%), chalcopyrite (9%),pyrrhotite (8%), and sphalerite (6%).
Gangue minerals are quartz (26%) and other silicates (19%, including hornblende, garnet, biotite, plagioclase, and muscovite
Average metal contents are 4.06 wt.% Cu, 2.48 wt.% Zn, 0.03 wt.% Pb, 0.36 ppm Au, and 94 ppm Ag which were observed by atomic absorption spectrometry (AAS)
![Page 4: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/4.jpg)
TEXTURE:
Pyrite occurs as euhedral to subhedral porphyroblastic crystals.
Pyrrhotite grains in the matrix are mostly hexagonal (Gu et al., 2001b).
Chalcopyrite and sphalerite also occur as subhedral to anhedral grains in the matrix
Most gangue minerals form globular textures, 2 to 5 mm in size.
![Page 5: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/5.jpg)
INSTRUMENTATION AND METHODOLOGY:
It was conducted in a horizontal compression chamber on a Changjiang 500 triaxial rock stress machine at the Guiyang Institute of Geochemistry, Chinese Academy of Sciences.
Argon gas provides the confining pressure, which is measured by means of a Heise gauge with a maximum capability of 600 Mpa with <1% uncertainty.
Auto-regulator transformer
The axial load was applied to the sample through a hardened and polished steel piston, 1.9 cm in diameter.
![Page 6: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/6.jpg)
CONTINUED….
The magnitude of the axial load is measured outside of the chamber by means of a load cell containing a resistance bridge of four foil strain gauges.
Ore sample for each run was cut into a cylinder 40 mm in length and 17 mm in diameter, and immersed in solution of 20 wt.% NaCl for 260 h.
The sample was enveloped in an aluminium foil and then mounted in a graphite tube.
At the termination of each experiment, power for the furnace was turned off, but pressures were held constant while the specimen cooled to room temperature.
![Page 7: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/7.jpg)
CONDITIONS FOR THE 4 RUNS:
![Page 8: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/8.jpg)
RESULTS
![Page 9: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/9.jpg)
DEFORMATION AND MECHENICAL REMOBILIZATION
Set of release fractures: Perpendicular to sample length
Become much better developed with increasing temperature
PYRITE:
Cataclastic deformation
Rotation shows plastic behavior of surrounding material
![Page 10: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/10.jpg)
CHALCOPYRITE-PYRRHOTITE-SPHALERITE
Plastic deformation with only local cataclastic textures
Deformation bands and twins
![Page 11: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/11.jpg)
CHEMICAL REMOBILIZATION: SULPHIDE VEINLETS
Cross-cut Pyrite-porphyroclasts
Show no displacement along strike
Abundance: Chalcopyrite > Pyrrhotite > Spherite
Chemical remobilization:
Discontinuity outside the grains
Change in composition of Sphalerite
![Page 12: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/12.jpg)
SULPHIDE VEINLETS: EFFECT OF TEMPERATURE
Remobilization becomes more intense with increasing temperature At 362o C :
> 2vol% 55% Chalcopyrite, 45% Pyrrhotite, 1% Sphalerite
At 682o C : 5%vol% 80% Chalcopyrite, 20% Pyrrhotite, 1% Sphalerite
![Page 13: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/13.jpg)
CHEMICAL REMOBILIZATION:SULPHIDE MICROCRYSTALLITES
Space fillings Same minerals welded by same mineral e.g Chalcopyrite
Aggregates of worm-like bodies Pure pyrite growth along fissures of Chalcopyrite
Lower in relief
![Page 14: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/14.jpg)
DISCUSSION
![Page 15: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/15.jpg)
MECHANISMS OF DEFORMATION
Minerals exhibit various degrees of cataclastic deformation in low-temperature (362C)
The strength of minerals decreases markedly with increasing temperature.
brittle-ductile transition of pyrite
brittle-ductile transition of pyrrhotite, chalcopy- rite, and sphalerite
Annealing and recrystallisation
Annealing of pyrrhotite.
![Page 16: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/16.jpg)
MECHANISMS FOR CHEMICAL REMOBILISATION
All the present experiments were performed at temperatures below the melting points of all the sulfides in the samples (Vaughan & Craig, 1997; Stevens et al., 2005; Sack & Ebel, 2006)
Most of the veinlets cutting pyrite porphyroclasts were formed by chemical remobilisation
![Page 17: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/17.jpg)
THIS CONCLUSION IS SUPPORTED BY THE FOLLOWING EVIDENCE:
1. the amout of remobilised chalcopyrite in most veinlets markedly exceeds the remobilised pyrrhotite, particularly in the high temperature runs
2. sulfides in many veinlets are not connected to the same sulfides outside the pyrite cracks
3. pyrite grains are replaced by chal- copyrite in some of the runs
4. chemical composition of remobilised sphalerite in the veinlets deviates from that of the residual sphalerite.
![Page 18: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/18.jpg)
GEOLOGICAL APPLICATIONS
Syn-tectonic remobilisation of sulfides in the natural system is a complex process, and would be affected conspicuously by varying factors, such as:
strain rate,
temperature,
fluid property,
composition of the original ore, and;
time length for the process
![Page 19: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/19.jpg)
CONT.
The present experiments show, however, that the extent of mechanical translocation is limited in comparison to chemical remobilisation.
The present experiments show that sulfides vary in ability of chemical remobilisation, particularly at higher temperatures.
The present experiments show that remobilisation could substantially modify the geometry and distribution pattern of syn- genetic orebodies, and produce a range of textures characteristic of epigenetic mineralisation
![Page 20: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/20.jpg)
CONT.
The present experiments demonstrate that remobilised sul- fides select preferentially pre-existing sulfide minerals, particularly pyrite, as substrate for overgrowth
Experiments and geology research suggest that pyrite is a favourable substrate for gold precipitation (Chen & Fu, 1992; Larocque & Hodgson, 1995; Zhang et al., 1996; Simon et al., 1999; Zhou et al., 2000; Gu et al., 2001a, 2007)
![Page 21: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/21.jpg)
ACKNOWLEDGMENTS
This research was jointly supported by Natural Science Foundation of China (no. 40872064) and Foundation for Doctorial Research, Ministry of
Education of China (no. 20060284013). We wish to thank Prof. Sun Yuan for his helpful discussion with the authors. The authors are also grateful to
Yasushi Watanabe and one anonymous RGE reviewer for their constructive comments and language corrections on the early manuscript for this
paper.
![Page 22: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/22.jpg)
REFERENCES
Barton, P. B. Jr. (1973) Solid solution in the system Cu-Fe-S Part I: the Cu-S and Cu-Fe-S joins. Econ. Geol., 68, 455–465.
Bellot, J. P. (2004) Shear zone-hosted polymetallic sulfides in the south Limousin area, massif central, France: remobilized sulfide deposits related to Variscan collisional tectonics and amphibolite facies metamorphism. Econ. Geol., 99, 819–827.
Berger, A. and Stu Pnitz, H. (1996) Deformation mechanisms and reaction of hornblende: examples from the Bergell tonalite (Central Alps). Tectonophysics, 257, 149–174.
Bourcier, W. H. and Barnes, H. L. (1987) Ore solution chemistry: VII. Stabilities of chloride and bisulphide complexes of zinc to 350oC. Econ. Geol., 82, 1839–1863.
Bursnall, J. T. (1989) Mineralization and shear zones. Geology. Ass. Can., Short Course Notes, 6, 1–299.
SO0o0 0on..;)
![Page 23: SULFIDE REMOBILISATION FROM SULFIDE ORE AT HIGH](https://reader033.vdocuments.us/reader033/viewer/2022052412/558393ddd8b42a9e528b50d5/html5/thumbnails/23.jpg)