tone 2

alarm

tone 3

all clear

AC surge arrestor

Receiver to Transmitter interface cable protection

The lightning protection bulkhead offered by Wxline should be installed and properly bonded to a conductor that is near and common to the building earth ground system. To further improve personal safety and equipment protection during a local thunderstorm, a secondary surge arrestor (for commercial AC power) should be installed at the building service entrance (per NEC). In addition, the RF cable used by WAVE equipment should enter the building at the service entrance and should pass through an appropriate, grounded RF surge suppressoror a ground block at the building service entrance.

Interface Cable—from Receiver to Transmitter (via surge arrestor)

Copper ground plate

Bond strap to buildingelectrical ground

Interface cable to Receiver relay

To outdoor antenna (via RF surge arrestor or ground block at the buildingservice entrance)

Wood mounting board

White board with copper ground plate

Strike Guardinline switchingpower supply

To AC power

Power in

Power in

Equipment bond strap to copper plate

WAVE Transmitterinline switchingpower supply

Antenna surge arrestor

Copper bond strap betweenReceiver and Transmitter (under wall-mount plates)

WARNING - DANGERNever touch WAVE or Strike Guard equipment

during a local thunderstorm - you could get

shocked or killed!

Strike Guard Lightning Data Receiver/WAVE Transmitter Lightning Protection Bulkhead Installation LLC

3924 NORTH CALLE CASITA • TUCSON, AZ 85718 USATEL: 520.615.9999 • FAX: 520.615.0030TOLL FREE: 800.615.0340 • www.wxline.com