1. An opening hole of 35mm diameter is required on sink top or work top for installation of tap.2. Slide the rubber O-ring ⑨, base ⑧, rubber ⑦ up to the base of tap;3. Install the plastic cover ⑥ to the A hole under the base of the tap; the connecting pipe ⑩ to the B hole and 2 flexible hoses ⒀ to C and D;4. Place the tap through the tap hole;5. Place the skid proof rubber ⑤ and the fixing sheet ④ through the connecting pipe and close to the sink or worktop;6. Tight the nut ③, make sure the tap is stable;7. Connect the pull-out pipe to the connecting pipe ⑩;8. Place the weighting ball 10cm up the lowest point of the pull-out hose.

●Before installation, please ensure that the following work

conditions are adhered to:

-Water temperature between 0˚C - 90˚C

-Water pressure between 0.05MPa – 1.0MPa. Pressure reducing

valve is necessary if pressure exceeds 1.2MPa

-Avoid major pressure differences between hot and cold water

supply

●Flush pipes thoroughly before and after installation to ensure

water supply is free of any debris.

●Inspect tap fitting and debugged to its best. Do not attempt to

disassemble fitting on your own.

●Use thread sealant tape (PTFE) on any screw joining

connections and ensure all joints are securely tightened.

ETM-E3680P

9

8

10

A

BC D

Φ35mm

2 6~10cm

This . FIAMMA SDN. BHD. will not be held responsible for the use of superseded or voided specifications.Fabricatoe must check for cut-out accuracy.

specification is subject to change without notice

Stainless Steel Mixer Tap