ssnp series ssnz · 2020. 1. 23. · * soft-start time and soft-down is same time. 0 0 20 40 60 80...
TRANSCRIPT
DIN rail mounting typePower Controller
SSNPSeries
SSNZSeries
R
(Single Phase Thyristor Unit)
Super Slim Design.Digital power controller Digital power controller
Slim width of 21.5mm
Easily wired
High performance and function<Linear input/output characteristic>
<Auto-detecting power frequency>
136.5
(Unit : mm)
100
78
Protective cover
21.5
172mm
4 to 20mA DC
85 to 264V AC
<Rapid response>With rapid response of 1 cycle or less, SSNP/SSNZ quickly responds to settinginput changes.
SSNP/SSNZ automatically selects power supplyfrequency 50 or 60Hz.
<Available to manual control>Available to manual control by externalvolume.
TemperaturecontrollerFB400/900<Close mounting 8 units>
* Same size for 15A and 25A types.
* Maximum load current will vary depending on number of close mounted units.
Actual size
0
100
4 Input (mA) 20
A/M R/LR/S
FB400
PV
SV MV
Load
<Ramp-up/Ramp-down (Soft start) function>
1
2
3
4
SOFTSTART
INPUT: DC4 - 20mA
LOAD: AC85 - 264V
T1
L1
L2SSNP-15F
INPUT
R
MADE IN JAPAN
15A
1
2
3
4
SOFTSTART
INPUT: DC4 - 20mA
LOAD: AC85 - 264V
L1
T1
L2SSNP-15F
INPUT
R
MADE IN JAPAN
15A
1
2
3
4
SOFTSTART
INPUT: DC4 - 20mA
LOAD: AC85 - 264V
L1
T1
L2SSNP-15F
INPUT
R
MADE IN JAPAN
15A
1
2
3
4
SOFTSTART
INPUT: DC4 - 20mA
LOAD: AC85 - 264V
L1
T1
L2SSNP-15F
INPUT
R
MADE IN JAPAN
15A
1
2
3
4
SOFTSTART
INPUT: DC4 - 20mA
LOAD: AC85 - 264V
L1
T1
L2SSNP-15F
INPUT
R
MADE IN JAPAN
15A
1
2
3
4
SOFTSTART
INPUT: DC4 - 20mA
LOAD: AC85 - 264V
L1
T1
L2SSNP-15F
INPUT
R
MADE IN JAPAN
15A
1
2
3
4
SOFTSTART
INPUT: DC4 - 20mA
LOAD: AC85 - 264V
L1
T1
L2SSNP-15F
INPUT
R
MADE IN JAPAN
15A
1
2
3
4
SOFTSTART
INPUT: DC4 - 20mA
LOAD: AC85 - 264V
L1
T1
L2SSNP-15F
INPUT
R
MADE IN JAPAN
15A
1
2
3
4
SOFTSTART
INPUT: DC4 - 20mA
LOAD: AC85 - 264V
L1
T1
L2SSNP-15F
INPUT
R
MADE IN JAPAN
15A
15A 25A
15A 25A
SSNPSeries
SSNZSeries
Phase control type
Zero-cross control type (Continuous proportion)
Output (%)
Compact size, even with a heatsink Easily mounted on a DIN-rail Linear output Rapid response
* Soft-start time and soft-down is same time.
00
20
40
60
80
10095% (SSNP)
4 8 12 16 20 24
100%
External Dimensions
136.5128.5
78 90 100
Protection cover
21.5
10.8
(Unit:mm)
15A 25A
* Same dimension for 15 and 25A types.
15A 25A
SSNZ-15F
Screw mounting dimensions
9186.6
2-M4X8
M3.5X6
DIN rail mounting
Panel
100% (SSNZ)
0
5
10
15
20
25
30
12
21
18.2
11.5
-20 0 20 40 60
3 units close horizontal mounting Ambient temperature (ºC)
8 units close horizontal mounting
35
Rated load current : 25A type
Rated load current : 15A type
60
22.0
Specifications
Control methodRated load currentApplicable loadInput signalMin.load currentOutput voltagerangeResponse timeCooling method
Power supply voltage
Power frequencyAllowable ambient temperatueAllowable ambient humidity
Dielectric voltage
Dielectric resistance
Mounting direction
Mounting method
Weight
Standard functions
Phase control (SSNP), Zero-cross control (SSNZ)15A AC, 25A ACLinearity (R : Resistive) load4 to 20mA (Input impedance : 250Ω)100mA AC *10 to 95% of rated voltage (SSNP) 0 to 100% of rated voltage (SSNZ)1 cycle or less (without soft start) *2 Natural convection85 to 264V AC (Including power supply voltage variation) [Rating : 100 to 240V AC]
50/60Hz (Automatic discriminating)
-20 to +60ºC
5 to 95%RH (Non-condensing)
Between input/volume, output terminals and case : 100MΩ or more (500V DC) Between input/volume, output terminals and case : 1500V AC for one minute Vertical direction or horizontal direction *3
DIN rail or screw mounting
Approx 260g
Soft-start/Soft-down : Approx 0.5 to 13 sec (SSNP) *2 Approx 0.5 to 40 sec (SSNZ) *2 External volume (Manual control)
*1 Continuity angle tend to be narrower when the load with minute current applied. Please allow your time to pre-check the function. *2 The top volume adjuster reach MAX when turned clockwise and reach ZERO when turned counter-clockwise. The ratings of approx.0.5 to 13sec (0.5 to 40 sec) shows changing time of the power from 0 to 100 or 100 to 0. *3 When mounting is horizontal direction, the load current should be below 70% of the specified ratings.
Temperature characteristics of load current
Output (%)
Loadcurrent
(A)
Input (mA)
Input - Output characteristics
Soft-start/Soft-down
Soft-start time Soft-down time
Output
Inputsignal
Mounting
Panel
UP
DOWN
UP
DOWN
Horizontal mounting
Vertical mounting
* The load current should be below 70% of the specified ratings.
φ4.6φ4.6
φ4.6X5.6
10.8±0.3
3-φ4.6 or M4
6-φ4.6 or M4
90±
0.3
SSNZ-25FSSNP-15F SSNP-25F
UL508 category No. NRNT2Compliance with standards
Model Code
External Wiring
Volume (Manual setter)SSNP-15F
SSNP-25F
SSNZ-15F
NPZP-S01
SSNZ-25F
Printed in Japan : APL.2005 OBB8H(Y) All Rights Reserved.CPZSSN01E
4 to 20mA DC
Temperature controller
Example of connection with temperature controller
Example of manual control used external volume
1+
2-
85 to 264V AC
(Unit : mm)
(Heater)
A/M R/LR/S
FB400
PV
SV MV
Load
(HINODE ELECTRIC CO.,LTD)
(HINODE ELECTRIC CO.,LTD)
L1
L2
T1
FB400/900
Scale plate
48
48
10
M9 x 0.752 10
38
9.5
76
35
M5 x 1022
φ10.4
φ3φ3.2
35M5
Fast blow fuse
Recommended fuse
Fuse holder
3
4
L1
T1
L2
0
20
40
60
80
100
0 2025%
40 60 80 100Turn Rate (%)
Volume - Output characteristics
660CF15 (15A type)
660CF25 (25A type)
FU-30 (15A/25A type)
MAX.
NPZP-S01
ManualOutput
Phase control
Zero-cross control
The waveform of the load power is switched at a desired phase angle θ to provide smooth control.
Power is switched on and off when the supply voltage is at 0V. This system suppresses high frequency noise inherent to phase control.
• Before operating this product, read the instruction manual carefully to avoid incorrect operation. • This product is intended for use with industrial machines, test and measuring equipment. It is not designed for use with medical equipment.
• If it is possible that an accident may occur as a result of the failure of the product or some other abnormality, an appropriate independent protection device must be installed.
• When installing this product, avoid the following: Direct exposure to sunlight. Direct contact with water. Corrosive environments. Hazardous areas containing explosive or flammable gases. Vibration or shock. Areas subject to electrical noise caused by inductive interference, static electricity or magnetic fields.
SafetyWarning
(RIKA KOGYO CO.,LTD)HEAD OFFICE : 16-6, KUGAHARA 5 CHOME OHTA-KU TOKYO 146-8515 JAPAN PHONE : 03-3751-9799 ( +81 3 3751 9799 ) Email : [email protected] FAX : 03-3751-8585 ( +81 3 3751 8585 ) http://www.rkcinst.com/
R
Caution for imitated products
As products imitating our product now appear on the market, be careful that you don't purchase these imitated products. We will not warrant such products nor bear the responsibility for any damage and/or accident caused by their use.
Rated load current : 15A
Rated load current : 25A
Rated load current : 15A
Rated load current : 25A
Phase control (SSNP series)
Zero-cross control (SSNZ series)
(Resistance : 2kΩ, 15C)
Accessories
Volume
K
φ6
φ14.
8
φ24
φ2.8
1
(Unit : mm)
* Same dimension for 15 and 25A types.
Screw mounting dimensions
Fast blow fuse
85 to 264V AC
Fast blow fuse
(Heater)
Load
*1 Please purchase volume separately. (Type: NPZP-S01)
• It cannot be used combining a temperature controller. (It does not function as "Gradient setting")
Volume: 2kΩ *1
Output(%)