square and rectangular duct
TRANSCRIPT
-
7/24/2019 Square and Rectangular Duct
1/13
Proper Installation
and Working of
different Air
Conditioning Units
-
7/24/2019 Square and Rectangular Duct
2/13
SQUARE AND RECTANGULAR DUCT
Supply duct
Air handler (blower)
Supply
registersReturn air fromthe occupied space
-
7/24/2019 Square and Rectangular Duct
3/13
Flexible Duct
Supply
Return
Flexible canvas
duct connector
-
7/24/2019 Square and Rectangular Duct
4/13
FLEXIBLE DUCT
Flexible Duct
Supply register
-
7/24/2019 Square and Rectangular Duct
5/13
ELECTRICAL INSTALLATION
Care should be taken whenever working on oraround electrical circuits
Power supply must provide correct voltage andwire sizeSplit systems require two power suppliesThere should be a service disconnect close toeach piece of equipmentControl voltage is obtained through a step-downtransformer
-
7/24/2019 Square and Rectangular Duct
6/13
Wire used for running low voltage control wiring is
color-coded, usually in the range of 18 gage
-
7/24/2019 Square and Rectangular Duct
7/13
INSTALLING THE WINDOW AC
All components are in one cabinet Range from window unit size to over 100 tons
Air-cooled equipment is most common inresidential and light commercial applications
Unit vibration should not be transmitted to thestructure
Duct connections must be water tight andinsulated
Crankcase heat must be energized before thesystem is started up
-
7/24/2019 Square and Rectangular Duct
8/13
INSTALLING SPLIT SYSTEM AIR
CONDITIONERS
Air handler must be secured or mounted properly
Access to the unit must be considered beforeinstalling
Condensate must be properly removed
Average condensate is 3 pints per hour per ton
Auxiliary drain pans
Used when the evaporator is above the conditioned space Piped to a conspicuous location
-
7/24/2019 Square and Rectangular Duct
9/13
Trapped condensate line
Floor drain
-
7/24/2019 Square and Rectangular Duct
10/13
Trapped condensate line
Condensate pump
Condensate pump discharge
-
7/24/2019 Square and Rectangular Duct
11/13
THE SPLIT SYSTEM CONDENSING UNIT
Discharged air must not re-circulate
Piping is connected to the condensing unitfrom the evaporator
Units must be able to be serviced properly
Units should be set on pads
Condensing units should be located in the
shade Noise should not be objectionable
-
7/24/2019 Square and Rectangular Duct
12/13
Piping to and from air
handler
Air must be able to circulate
freely
Unit set on pad
Unit located far from
windows
-
7/24/2019 Square and Rectangular Duct
13/13