7/30/2019 Specifications - Sergeant Major of the Army

1/2

1 of 2

NOT MEASUREMENT SENSITIVE

MIL-DTL-14639/28E1 October 1998SUPERSEDINGMIL-DTL-14639/28D29 January 1996

DETAIL SPECIFICATION SHEET

INSIGNIA, GRADE, SERGEANT MAJOR OF THE ARMY (E-9), ARMY

This specification is approved for use by all Departments and Agenciesof the Department of Defense

The requirements for acquiring the product described herein shall consist of thisspecification sheet and the issue of MIL-DTL-14639 listed in that issue of the Department of Defense Index of Specifications and Standards (DoDISS) specified in the solicitation.

DASH NO.-1: Subdued-2: Bright

MATERIAL:-1: Red Brass, Yellow Brass, or Zinc Aluminum-2: Red Brass

FINISH:-1: Dull Flat Black Enamel with the Recessed Area Flat Olive Drab Enamel.-2: Soft Baked Enamel, Mirror-like Polished and shall match TIOH Metal Finish Chip

Number 1.

AMSC N/A FSC 8455DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.

Source: http://www.assistdocs.com -- Downloaded: 2012-03-10T22:15ZCheck the source to verify that this is the current version before use.

7/30/2019 Specifications - Sergeant Major of the Army

2/2

MIL-DTL-14639/28E

2 of 2

DIMENSIONS:HEIGHT: 1-1/2 inch (3.81 cm) (REF)WIDTH: 13/16 inch (2.06 cm) (REF)THICKNESS: 0.070 inch + 0.005 inch (0.178 cm + 0.12 cm)

NOTES:

1. The term (REF) refers to measurements taken from the Government furnished hubor die.

2. The prongs shall be located on a horizontal line 5/8 inch + 1/16 inch (1.59 cm + 0.16cm) above the lowest point of the insignia, equidistant from each side and 11/16 inch +1/64 inch (1.75 cm + 0.16 cm) apart.

3. For Dash -1, the dull flat enamel shall be Black Chip Number 37038 and the recessedarea shall be Green (Olive Drab) Chip Number 34096, all conforming to FED-STD-595.For Dash -2, the soft baked enamel area shall be as indicated and conform to TIOH BlackColor Chip Number 26. Sufficient soft enamel shall be applied to cover the recessed areabut not obliterate the textured pattern.

4. Pierced areas shall be as indicated.

5. At the option of the manufacturer for commercial sale only, Dash -2 may bemanufactured using 22 karat gold plate with a mirror-like polished finish and nickelunderplating which shall match TIOH Metal Finish Chip Number 9.

CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision toidentify changes with respect to the previous issue due to the extent of the changes.

Custodian: Preparing activities:Army - IH Army - IH

Review activities: (Project No. 8455-0956)DLA - CT

Source: http://www.assistdocs.com -- Downloaded: 2012-03-10T22:15ZCheck the source to verify that this is the current version before use.