single nureva_whispertek_installguide january 21 2016

7/25/2019 SINGLE Nureva_whispertek_installguide January 21 2016

1/12

Whispertek surface single installaon guide

Span Ideaon system


2/12

WHAT YOULL NEED

2masking tape Straight edge Laser level 3Roller

Three (3) people toinstall the surface.

TABLE OF CONTENTS

Before you begin

Step 1 - Aligning the surface

Step 2 - Adhering the surface

3

4

7


3/12

WhisperTekTMSurface installationhttp://nureva-span.uservoice.com/knowledgebase/articles/603927

70F 21C

Use a pencil to make

a 1/4at the center of

the surface.

To avoid cracking, ensure your surface has reached

room temperature before unrolling. Allow the surface

to rest and flatten for 2 to 3 hours before installation.

BEFORE YOU BEGIN


4/12

STEP 1

ALIGNING THE SURFACE


5/12

Measure and markUse your laser level to project a line 1above the projected image.

Mark a 1vertical line at the center of

the projected image.

Your marks should extend above theline created by your laser level.


6/12

AA BC

Align the surface Secure the surface

Person Aalignsthe top of thesurface with thelaser level line.

Person Baligns thetop and right sideof the surface withthe laser level lineand centerline.

Do not remove the adhesive liner from the back of the surface yet.

Person Cwill tape the entire length of thesurface along the top and bottom edges.


7/12

STEP 2

ADHERING THE SURFACE


8/12

Remove tape from one half

Person A will remove the tape from

only the right side of the surface along

both the top and bottom edges.

Hold the surface in place

Holding the straight edge vertically, person C will press

the surface firmly against the wall approximately 4-6

to the left of the center mark.


9/12

Remove the adhesive liner

Person A will pull the surface away from the wall to allow

person B to reach where the adhesive liner is scored at the

back and remove it from that side of the surface.


10/12

1

CC AB

2 3

Begin adhering the surface to the wall

Starting from the center point and moving towards the right, person B will begin

to press the surface against the wall with overlapping up-and-down strokes to

prevent bubbles from forming under the surface.

As person B movestoward the edge of

the surface, person Awill slowly allow thesurface to move backtoward the wall.


11/12

Adhere the second half of the surface

Once the first half is adhered, remove the remaining tape and follow the

same process to adhere the second half of the surface to the wall.


12/12

Roller the surface

Apply pressure to the surface using the 3roller to promote

proper adhesion.

2016 Nureva Inc. All rights reserved. Nureva, Span, WhisperTek and the Span logo are trademarks of Nureva Inc. in the United States, Canada and other countries.

single nureva_whispertek_installguide january 21 2016

Documents