Hints• Cow Catcher

• Axle Peg

Cow Catcher

• These are NOT step-by-step directions. The goal is to provide guidelines and suggestions.

Cow Catcher

Make sure you create a sketch on the XZ PLANE

Cow Catcher

Dimensions for one side

Cow Catcher

Create 2D Sketch, then hold and drag up, then type 0.75

Cow Catcher

Cow Catcher

Use Project Geometry

Dimensions for other side

Cow Catcher

• Loft

• Shell (0.1)

• Create 2D Sketch (then use offset tool), dimension .1 from top, then extrude CUT 0.05

• Make pegs on back

Cow Catcher

Make sure you have the correct dimensions, then extrude .125 and chamfer

Axle Peg

Make sure you create a sketch on the XZ PLANE

Axle Peg

• Sketch half of cylindrical profile and revolve.

• 0.25/2, then 1, then unknown distance, then .031, create arc, then close shape

• Add dimensions

• .422/2, then arc=.236,

Axle Peg

Axle Peg

Make center mark coincident with (vertical) y-axis.

Axle Peg

• Finish sketch, revolve

• Make offset sketch plane: Create 2D Sketch, hold and drag -0.125

Axle Peg

Slice Graphics

Axle Peg

• Project Geometry of circle, finish sketch, extrude CUT (distance all)

Axle Peg

• New Sketch, use polygon tool to draw hexagon (6 sides) onto flat surface

Axle Peg

• Dimension 5/32, Extrude cut .111

• Chamfer bottom edge

• Use Thread tool with ¼ in offset