samsung galaxy pocket (gt-s5300) teardown · step 1 — samsung galaxy pocket (gt-s5300) teardown...
TRANSCRIPT
Samsung Galaxy Pocket (GT-S5300) TeardownThis is a Teardown of my old broken Samsung Galaxy Pocket (GT-S5300)
Written By: Ryan
Samsung Galaxy Pocket (GT-S5300) Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7
INTRODUCTION
This is a Teardown of my old broken Samsung Galaxy Pocket (GT-S5300)
Samsung Galaxy Pocket (GT-S5300) Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7
Step 1 — Samsung Galaxy Pocket (GT-S5300) Teardown
Remove the battery cover
Then remove the battery
Step 2
Remove all 4 screws
Samsung Galaxy Pocket (GT-S5300) Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7
Step 3
Slide a guitar pick between the sliver bezel and the rear of the phone
Slide it all the way around until the rear is loosened from the logic board and screen
Step 4
Remove LCD connector
Samsung Galaxy Pocket (GT-S5300) Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7
Step 5
Remove logic board from screen bylifting the logic board up andremoving the digitizer connector
Step 6
Remove the 5 screws to remove the shield
Samsung Galaxy Pocket (GT-S5300) Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7
Step 7
Remove what seems to be the antenna from the logic board
Step 8
Slide guitar pick between the digitizer and lcd
Make sure not to get under the black adhesive on the back be the digitizer
At the top of the digitizer there is a circuit be careful up there
Samsung Galaxy Pocket (GT-S5300) Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2017-06-18 09:07:17 PM.
Step 9
So that's my teardown for theSamsung galaxy pocket (GT-S5300)
Samsung Galaxy Pocket (GT-S5300) Teardown
© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7