safety wire presentation
TRANSCRIPT
![Page 1: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/1.jpg)
How to Use Safety Wire Pliersto install safety wire
Always wear safety glasses while handling safety wire
Caution:
![Page 2: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/2.jpg)
Make sure bolts are torqued to specCut enough safety wire to complete the taskFeed the wire through approximately half way through
![Page 3: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/3.jpg)
Wrap one end around the bolt head tightly.Start twisting the wire clockwise immediately upon exiting the bolt hole Leave no gaps
![Page 4: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/4.jpg)
Make two twists (clockwise)
![Page 5: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/5.jpg)
Run the wires approximately where they need to go. Then attach pliers and lockContinue twisting clockwise 8-10 twists per inchDo not over twist
![Page 6: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/6.jpg)
![Page 7: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/7.jpg)
Feed one wire through other bolt holeMake sure safety wire has a tendency to pull the bolts tighter
![Page 8: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/8.jpg)
Wrap one wire around the bolt headGo under the other wire
![Page 9: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/9.jpg)
Make two tight twists counter clockwise by hand
![Page 10: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/10.jpg)
Attach safety wire pliers and lockContinue twisting counter clockwise until about ¼ to ½ inch.
![Page 11: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/11.jpg)
Cut wire Fold end to make a “pig tail”
![Page 12: Safety wire presentation](https://reader034.vdocuments.us/reader034/viewer/2022042815/557c336ed8b42a28208b4642/html5/thumbnails/12.jpg)
Congratulations! You just made a proper safety
Always wear safety glasses while using safety wireAvoid nicking or damaging the wire in any way. This weakens it.Avoid any gapsVisit myAandPlicense.com for more information and find aviation mechanic schools near you!