s e advanced feature - cloudinary

2
CB-224 SERIES Advanced Feature 4-RU Ceiling Boxes Plenum Rated Metal Products Group CB-224 SERIES FSR Inc. 244 Bergen Boulevard, Woodland Park, NJ 07424 Phone: 973.785.4347 · Fax: 973.785.4207 Web: www.fsrinc.com · E-mail: [email protected] Order Desk: 1-800-332-FSR1 LIT1414B · Deeper box design to carry pull-down 4-RU rack cage that is 12” high, and capable of carrying 25 lbs. of electronic equipment · Available in 4 versions, non-pole mount and pole mount, both with or without “smart” electronics. · Pull-down handle · Cable guides · 4-RU rack cage with gas-spring assisted ball-bearing slide · Edge-protected bundled cable inlet cavity on each side of the box, filled with flame retardant foam seal. · 1”/1.25”/1.50” trade-size knockouts, one set per side of the box, with (2) 0.5”/.75” trade-size KOs for line voltage wiring. · 1 3 / 8” clear space on both sides of rack cage when inside the box, to allow for wire bundles. · 2-RU of angle-adjustable rack mounting surfaces to facilitate mounting and visibility of 1-RU/2-RU patch panels. · 5 internal outlets · 1 external outlet · Smart module with Fan (option): Air Flow: 29 CFM at .08 mmHg Noise level: 29 dB A weighted The CB-224 series is a 2’ x 2’ high capacity ceiling box designed to fit into a standard 2’ x 2’ or 2’ x 4’ drop ceiling. It features a drop-down 4RU cage for easy installation and mounting of rack equipment. Cable guides for ser- vice loops are provided to allow the equipment to be connected in the down position and then slid up into place. The drop-down cage features pneumatic assistance to counter some of the weight of the equipment installed. The CB-224 has 6 AC outlets in the box and 1 in the room. A master power switch is accessible from the room. The ‘P’ option adds an adapter for projector pole mount- ing. This allows cabling to pass from inside the ceiling box, down the pole and to the projector, providing a nice clean installation. The ‘S’ option adds cooling fans and the Smart Power module. This module allows the power in the box to be either remotely controlled or switched based on the cur- rent draw of specific outlets. In this energy saving mode, the power in the box is switched on and off automatically with the projector to conserve power. The CB-224RKRL optional rack rail hardware kit adds two additional rack spaces at the rear of the CB-224 cage for cable management and mounting of accessories. There are a variety of accessory internal mounting brack- ets available including one gang, two gang, six IPS and twelve IPS openings. They can be positioned and mount- ed as needed using various pilot holes located at the top of the cage. DESCRIPTION FEATURES FEATURES DESCRIPTION APPLICATIONS APPLICATIONS Anywhere a Projector or Display is ceiling mounted · Conference centers · Schools · General Meeting Facilities · Training Facilities · Airports · Museums NOTE: For use with the common “T” grid drop ceiling systems, not compatible with all drop ceiling systems.

Upload: others

Post on 13-Nov-2021

1 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: S E Advanced Feature - Cloudinary

CB-224 SERIESAdvanced Feature4-RU Ceiling BoxesPlenum Rated

Metal Products Group

CB-224 SERIES

FSR Inc.244 Bergen Boulevard, Woodland Park, NJ 07424 Phone: 973.785.4347 · Fax: 973.785.4207Web: www.fsrinc.com · E-mail: [email protected] Desk: 1-800-332-FSR1 LIT1414B

· Deeper box design to carry pull-down 4-RU rack cage that is 12” high, and capable of carrying 25 lbs. of electronic equipment· Available in 4 versions, non-pole mount and pole mount, both with or without “smart” electronics.· Pull-down handle· Cable guides· 4-RU rack cage with gas-spring assisted ball-bearing slide· Edge-protected bundled cable inlet cavity on each side of the box, filled with flame retardant foam seal.· 1”/1.25”/1.50” trade-size knockouts, one set per side of the box, with (2) 0.5”/.75” trade-size KOs for line voltage wiring.· 13⁄8” clear space on both sides of rack cage when inside the box, to allow for wire bundles.· 2-RU of angle-adjustable rack mounting surfaces to facilitate mounting and visibility of 1-RU/2-RU patch panels.· 5 internal outlets· 1 external outlet · Smart module with Fan (option):

Air Flow: 29 CFM at .08 mmHgNoise level: 29 dB A weighted

The CB-224 series is a 2’ x 2’ high capacity ceiling boxdesigned to fit into a standard 2’ x 2’ or 2’ x 4’ drop ceiling.

It features a drop-down 4RU cage for easy installationand mounting of rack equipment. Cable guides for ser-vice loops are provided to allow the equipment to beconnected in the down position and then slid up intoplace. The drop-down cage features pneumatic assistance tocounter some of the weight of the equipment installed.

The CB-224 has 6 AC outlets in the box and 1 in theroom. A master power switch is accessible from theroom.

The ‘P’ option adds an adapter for projector pole mount-ing. This allows cabling to pass from inside the ceilingbox, down the pole and to the projector, providing a niceclean installation.

The ‘S’ option adds cooling fans and the Smart Powermodule. This module allows the power in the box to beeither remotely controlled or switched based on the cur-rent draw of specific outlets. In this energy saving mode,the power in the box is switched on and off automaticallywith the projector to conserve power.

The CB-224RKRL optional rack rail hardware kit adds twoadditional rack spaces at the rear of the CB-224 cage forcable management and mounting of accessories.

There are a variety of accessory internal mounting brack-ets available including one gang, two gang, six IPS andtwelve IPS openings. They can be positioned and mount-ed as needed using various pilot holes located at the topof the cage.

DESCRIPTION FEATURESFEATURESDESCRIPTION

APPLICATIONSAPPLICATIONSAnywhere a Projector or Display is ceiling mounted· Conference centers · Schools · General Meeting Facilities · Training Facilities · Airports · Museums

NOTE: For use with the common “T” grid drop ceiling systems, not compatible with all drop ceiling systems.

Page 2: S E Advanced Feature - Cloudinary

CB-224 SERIES

244 Bergen Boulevard, Woodland Park, NJ 07424 Phone: 973.785.4347 · Fax: 973.785.4207Web: www.fsrinc.com · E-mail: [email protected] Specifications are subject to change without notice.

MADE INTHE USA

PLENUM RATED: Conforms to UL 2043: UL Standard for Safety Fire Test for Heat and Visible Smoke Release for Discrete Products and Their Accessories Installed in Air-Handling Spaces.

SAFETY RATED: Conforms to: UL 60950-1: Information Technology Equipment - Safetyand certified to CSA 22.2 60950-1: Safety of Information Technology Equipment

ETL approved and recognized for use in the State of California. Division of State Architect (DSA) suspension approvals must be sought by contractor prior to certain installations.

AGENCY APPROVALSAGENCY APPROVALS

CB-224CB-224

MOUNTING TAB HOLE-TO-HOLE

DISTANCE

23.12 SQUARE

21.44

1.651.65

11.00

23.69 SQUARE

24.43OPTIONAL MOUNT BRACKET

THREADED ROD-TO-ROD DISTANCE

12.22

7.90CARRIAGEEXTENDED

MOVEABLE RACK MOUNTING EARS SET IN THE 4-RU

POSITION

12.00 2.09

NON-POLE MOUNT

VERSION

POLE MOUNT

VERSION

INTERNAL CLEARANCE

10.64 2.78INTERNAL

CLEARANCE

(2) INLET CAVITY

MOVEABLE RACK MOUNTING EARS

SET IN THEIR ALTERNATE

2-RU/2-RU POSITION

USABLE RACK UNIT DEPTH:14.27 (18.93 FOR NON-POLE)

USABLE RACK UNIT DEPTH:13.61 (18.24 FOR NON-POLE)

Edge-protected bundled cable inlet

cavity on each side ofthe box, filled withflame retardant foam seal.

2-RU of angle-adjustable rack mounting surfacesto facilitate mounting and visibility of 1-RU/2-RU

patch panels.

Optional SG-120HW

The optional SG-120HWis a “Type 2 SurgeProtective Device” usedto protect branch circuits against damagefrom electrical transientsoccurring on the ACline. It provides protec-tion against transients in all 3 modes; Line toLine, Line to Neutral,and Neutral to Ground.A diagnostic LED indicates ground presence, system power and that surgeprotection is active.

1”/1.25”/1.50” trade-sizeknockouts, one set per side of the box, with (2) 0.5”/.75”

trade-size KOs for line voltage wiring.

13⁄8” clear space on both sidesof rack cage when inside the

box, to allow for wirebundles.

5 internal outlets1 external outlet

Smart Module Fan

4-RU rack cage with gas-spring assisted ball-bearing slide.

Available in 4 versions: non-pole mount and pole-mount, both with or without “smart” electronics.

Deeper box design to carry pull-down 4-RU rack cage thatis 12” high, and capable of

carrying 25 lbs. of electronic equipment.

Pull-down handle

Cable guides

Product weight: 50.30 lbsShipping weight: 60.00 lbs.