ruger 22-45 bolt dis assembly

3
Ruger 22/45 Disassembly of the Bolt 1. Field Strip the gun. 2. Lift out Recoil Spring Assembly (Fig. 1).

Upload: api-3840428

Post on 10-Apr-2015

1.432 views

Category:

Documents


2 download

TRANSCRIPT

Page 1: Ruger 22-45 Bolt Dis Assembly

Ruger 22/45

Disassembly of the Bolt

1. Field Strip the gun.

2. Lift out Recoil Spring Assembly (Fig. 1).

Page 2: Ruger 22-45 Bolt Dis Assembly

3. Remove Firing Pin Stop (Fig. 2 red arrow).

4. Lift out Firing Pin and the Rebound Spring and Support (Fig 3).

5. Push down and hold the Extractor Plunger (Fig. 4 red arrow). Rotate the top of the

Extractor to where the hook is trying to touch the bolt face (Fig. 4 blue arrow), to

make the bottom of the Extractor appear . Slide the Extractor sideways at 90 degrees

to remove (Fig. 4 green arrows). You may want to hold the bolt so the green arrows

point at the ground to allow gravity to help remove it.

6. Release pressure and remove the Extractor Plunger and Spring.

Page 3: Ruger 22-45 Bolt Dis Assembly

Assembly of the Bolt

1. Insert Extractor Plunger and Spring with the longest end facing out (Fig. 5).

2. Push the Extractor down on the Plunger until the tip of the Extractor touches the

bolt face (Fig. 6 red arrow), then push the Extractor in to lock it into place (Fig. 6 blue

arrow).

3. Install Rebound Spring and Support, bent end down (Fig. 7 blue circle).

4. Install the Firing Pin so that the end of the Rebound Spring is touching the part

sticking out below the Firing Pin (Fig. 7 red lines).

5. Install the Firing Pin Stop by pushing forward on the Firing Pin to line up the holes.

6. Install the Recoil Spring Assembly with the curved end matching the curve of the

bolt.

7. Reassemble the gun.