rpft exam questions
TRANSCRIPT
Pass (RPFT) Registry Examination for Advanced Pulmonary
Function Technologists exam in just 24 HOURS!
100% REAL EXAM QUESTIONS ANSWERS (RPFT) Registry Examination for Advanced Pulmonary
Function Technologists
Buy Complete Questions Answers File from
http://www.exams4sure.com/NBRC/RPFT-practice-exam-
dumps.html
100% Exam Passing Guarantee & Money Back Assurance
Sample Questions
Question No 1:
Which of the following is the most reliable method to estimate the effectiveness of standard
procedures to minimize the risk of cross-contamination during spirometry testing in a
pulmonary function laboratory?
A. Count the number of disposable mouthpieces used for 1 week.
B. Observe the handwashing behavior of each technologist.
C. Ask patients tested about laboratory hygiene.
D. Ask technologists if they wash their hands before each test
Answer: B
Question No 2:
While performing duplicate blood gas analyses, a pulmonary function technologist notes that
the second instrument gives consistently higher values forPaCO2and PaO2. Which of the
following is the most probable cause of higher readings from the second instrument?
A. The sample chamber temperature is greater than 37° C
B. An excessive delay occurred between running the two samples
C. The PO2and PCO2electrodemembranes have protein build-up
D. The sample chamber has a bacterial contaminate
Answer: A
Question No 3:
Which of the following problems may be identified by using an isothermal lung analog to
perform quality control on a body plethysmograph?
1. 1.Improperly calibrated mouth pressure transducer
2. 2.Obstructed or perforated pneumotachometer
3. 3.Increase in mechanical resistance
4. 4.Malfunctioning box pressure transducer
A. 3 and 4 only
B. 2 and 3 only
C. 1 and 4 only
D. 1 and 2 only
Answer: C
Question No 4:
An isothermal lung analog has the following specifications:
5-L glass bottle
2000 g of steel wool
Density of steel wool 5 g/cm3
Volume of connectors and bulb 100 mi-Repeated FRC measurements in the plethysmograph
result in a volume of 5.5 L. Which of the following should a pulmonary function technologist
do?
A. Remove 500 g ofsteel wool from the lung analog
B. Take the plethysmograph out of service
C. Recalculate the BTPS correction
D. Begin a biologic control program
Answer: D
Question No 5:
A pulmonary function technologist is reviewing an asthma action plan. The patient takes a
low-dose inhaled corticosteroid and a long-acting beta2-agonist twice daily. The patient's
personal best peak flow is 600 L/min. Which of the following instructions should be given to
the patient when the peak flow drops to 500 L/min?
A. Add montelukast (Singular).
B. Continue the current regimen.
C. Go to the emergency department.
D. Double the steroid dose.
Answer: A
Question No 6:
A treadmill belt stops for a fraction of a second each time the patient takes a step. A
pulmonary function technologist should
A. Instruct the patient to use the hand rails.
B. Tighten the belt.
C. Increase the speed of the belt.
D. Decrease the treadmill grade.
Answer: B
Question No 7:
Prior to an exercise study, a pulmonary function technologist finds that the patient's RER is
1.13. Which of the following best explains this finding?
A. Carbohydrate metabolism
B. Protein metabolism
C. Hypoventilation
D. Hyperventilation
Answer: D
Question No 8:
A 6-year-old child has a history of repeated episodes of wheezing and shortness of breath. A
pulmonary function technologist has difficulty obtaining repeatable spirometry results.
Which of the following tests should be performed next?
A. MVV
B. DLco
C. SGaw
D. SpO2
Answer: A
Question No 9:
A pulmonary function technologist is performing an exercise (stress) test on a patient with
severe COPD. As the test progresses, the patient shows signs of increasing dyspnea.
Measurements of inspiratory capacity decreased from 2.0 L to 1.5 L. Which of the following
most likely occurred?
A. Dynamic hyperinflation
B. Disconnected gas sampling line
C. Drift in the flow transducer
D. Acute decrease in FRC
Answer: D
Question No 10:
During exercise, a subject's oxygen consumption increases out of proportion to his cardiac
output. This is due to an increase in
A. Anaerobic metabolism
B. Alveolar ventilation
C. Coronary blood flow
D. Oxygen extraction.
Answer: C
Buy Complete Questions Answers File from
PDF Version + Test Engine Software Version
90 Days Free Updates Service
Valid for All Countries
http://www.exams4sure.com/NBRC/RPFT-practice-exam-
dumps.html