rp flyer - forward modelling
TRANSCRIPT
FORWARD MODELLING A Blueback Rock Physics Workflow in Petrel*
By Shila Jeshani
INTRODUCTION
ADVANTAGES:
STEP 1: GASSMANN FLUID SUBSTITUTION
STEP 2: ROCK PHYSICS MODELLING AND LITHOLOGY SUBSTITUTION
STEP 3: SYNTHETICS
Fluid
Substitution
1 3 2 Create &
Parameterise RPMs Synthetics
The forward modelling workflow allows variations in
seismic amplitude based on changes in pore fluids and
lithology to be modelled. The Blueback Rock Physics plug-
in provides an automated implementation of the forward
modelling workflow. This allows investigation of parameter
sensitivity in the Petrel Workflow Editor. Lithology
Substitution
Investigate variations due to changes in fluid content by creating mineral and fluid properties and defining gas and/or oil legs.
Rock Physics Modelling
Create, parameterise and
QC rock physics models
(RPMs). Choose from a
variety of industry standard
models.
Lithology
Substitution
Use RPMs to
investigate the
effects of changing
petrophysical
properties (volume
of shale, porosity,
pressure and
water saturation).
Create and QC
different synthetic
seismic data.
Single angle,
stacked or partial-
stack outputs can
be created.
Blueback Rock Physics works in multiple domains.
Run workflows on:
Wells: single or multiple well analysis
Model: 3D model properties from selected grid
Seismic: select 3D seismic volumes
Numeric: enter inputs and write results to message
log
Tools are all Petrel workflow enabled. *Mark of Schlumberger
Blueback Reservoir www.blueback-reservoir.com [email protected] | [email protected] Blueback Support Portal: support.blueback-reservoir.com
Property Prediction Apply Bayesian theory to find probable locations
of hydrocarbons and reservoir intervals
Fluid Substitution
Litho-facies Classification
Property Distribution Functions
Bayesian Classification
Tuning Effect Investigation Model the effects of your reservoir interval
pinching out by creating a tuning wedge
Litho-facies Classification
Blocky Modelling 1D
Tuning Wedge 2D/3D
Property Model Validation Create synthetic volumes to validate reservoir
model
Create and Parameterise Rock Physics Models
Generate Elastic Properties (in 3D model)
Impedances
Synthetics
Representative workflow:
Vary hydrocarbon saturations and petrophysical parameters within selected rock physics models to
observe changes in synthetics at the click of a button
Lithology substitution step: vary deltas
of water saturation, porosity and
pressure in iterative loops