Rubber Mallet

1

03131302769-4

770 Del Paso RoadSacramento, CA 95834-0308

Reco

mm

ende

d To

ols

Cont

ents

Royal HawaiianAdjustable Floating Chaise Lounge

70771/70772ASSEMBLY INSTRUCTIONS

Need Assistance?Call our Consumer Service Line:

See our web page: poolmaster.comeMail: info@poolmaster.com

800.854.1492

Product Care & StorageThis device is designed for comfort to lounge in the pool. Each Float is made of durable, non-corrosive materials. However, prolonged exposure to sunlight and pool chemicals can cause permanent weakening of product. To extend product enjoyment:1. Remove from pool when not in use.2. Rinse with plain water after each use.3. Store in a dry place away from direct sunlight and

pool chemicals.

For Safety:1. Do not jump on Lounge.2. Keep Lounge out of rough play.3. Make sure all nuts and bolts and attachments

are secured. Tighten as needed.4. Check regularly for wear and tear.

Lounge Seatwith Frame & Mounting Slides

8-32 x 5⁄8” Bolts (8)

8-32 x 1½” Bolts (8)

Mounting Caps (4)

Polyform™ Pontoons (2)

White End Caps (4)

Straight Front Crossbar (1)

CurvedRear Crossbar (1)

Flat-head Screwdriver

PhillipsScrewdriver

Ass

embl

y In

stru

ctio

ns

2

Step 1 Step 2

Step 3

• Turn the Lounge Seat upside down.• For proper alignment, match Color Dots on Curved Rear

Crossbar to the back of the Lounge Back. Attach to the back of the Lounge Seat by inserting Rear Crossbar into pre-installed Mounting Slide. Secure bar to Mounting Slide with Mounting Caps and four 8 -32 x 5/8” Bolts.

• For proper alignment, match Color Dots on Striaght FrontCrossbar to the back of the Lounge Back. Connect Straight Front Crossbar to the Lounge Seat by inserting Crossbar into pre-installed Mounting Slide. Secure bar to Mounting Slide with Mounting Caps and four 8 -32 x 5/8” Bolts.

• Insert White End Cap on each end ofboth the Curved Rear Crossbar and the Straight Crossbar.

Tip: Soften caps in warm water if di�cult to insert

poolmaster.com

• Place Floats on a table, workbench or on the original carton. Turn Polyform™ Pontoon bottom side up with the smaller end to the back of the table.

• Place the Straight Front Crossbar on the front groove of the Polyform™ Pontoon and the Curved Rear Crossbar on the rear groove of the Polyform™ Pontoon.

• Insert a 1.5” Bolt through the hole that is closerto the Lounge Seat Frame, one on each side of the Crossbar and into the molded nut of thePolyform™ Pontoon (Do not tighten until all boltsare in place).

• Finally, insert a 1.5” Bolt through the outside hole,one on each side of the Crossbars and into themolded nut of the Polyform™ Pontoon. Tighten all bolts.

Note: Complete lounge seat assembly from step 2 not shown.

Curved Rear Crossbar

Straight FrontCrossbar

White End Caps

Head

Foot

Note: Red Dots(On Right hand Sides)

Front Mounting Slides

Rear Mounting Slides

Mounting Slide

Mounting Bracket

Head