‘rig’ components audio amplifier/speaker stimulator dc strain gauge amplifier ac amplifier am...
TRANSCRIPT
‘Rig’ components
Audio Amplifier/SpeakerStimulatorDC Strain Gauge Amplifier AC AmplifierAM Amplifier Analog OscilloscopePower Supply
Metal plate is on tennis balls for vibration isolation .
Cables/ConnectionsBanana plugsBNC cables Alligator Clips
Adapters BNC-to-AlligatorBNC-to-Banana (male/female)Combinations (male/female)
SplittersBNC – ‘T’
Head StageAC Head Stage (male-female)DC Head Stage (female-female)Strain Gauge
Other Equipment
Pipette Pullers Stroboscope
Signal Analysis System SetupAdapters: 2 T’s, 3 BNC’SPlug in equipmentSignal generator to oscilloscope Ch 2
Adapters: alligator-to-BNCConnect to oscilloscope channel 2
Head Stage connected to AC amplifier
Connect AC Amp output (via T and BNC) to three data analysis devices To audio amp A/V adapter on rearTo 0scilloscope (channel 1) To PC: connect to Ch 0 on rack (upper left)
Work through part one of the electronics orientation handout
Audio
AC Amp
AM Systems AMP
DC AMP
Power supply
Stimulator
Oscilloscope
VI input
Headstage(input)
G1
G
2
Com
Stimulus Generator
Input Output
Using alligators, ground plate to cage and cage to rack
Make sure signal generator is off, remove connection from oscilloscope
Connect to signal generator to AC headstage Alligator to G1 and G2, not COM
Before turning on signal generator, check level of amplification- set amplifier to lowest amplification.
Work through part two of the equipment testing handout
PLEASE HAVE SOMEONE CHECK YOUR SETTINGS BEFORE TURNING ON AMPLIFIER
Audio
AC Amp
AM Systems AMP
DC AMP
Power supply
Stimulator
Oscilloscope
VI input
Headstage(input)
G1
G
2
Com
Stimulus Generator
Input Output
Using alligators, ground plate to cage and cage to rack
Get your electronics set before getting the speciminIs it plugged in?Is it turned on?Check connectionsCheck grounds (plate to cage, cage to rack)Is your amplification correct? Check settings in handoutIs your scaling (time base and gain/voltage) correct?
You can check the connections and settings on the demo rig or on a classmate’s rig.