The LED illumination kit for acrylic Wind Blocker.

6’ cable, 0.06” diameter 2 pin T- clamp

2 pin power connector Enclosure with 9 LEDs

RF remote

Install illumination module under the wind blocker.

Routing the cable from the LED module to the trunk

Move the passenger seat all the way forward, to get better access to the panel

behind the seat.

Release the top latch, but do not open the top all the way.

Remove these 3 pins to

remove this plastic panel

Route the cable from the LED

module to this position.

Attach the cable to the plastic

panel from behind and pull

the cable through the passage

to the trunk

Open the trunk and remove the passenger side lining and pull cable in.

Attach a T-clamp using pliers. LED will be connected parallel to the side marker

light. The pink wire must be connected to the red (or white) wire on the harness

and black to the black. Alternatively, the LED module can be connected to the

brake light (red wire) on the same connector, or the ACC power line (in this case

on/off control by remote only)

Attach 2 pin white connector (or black barrel type). All done!

Put back all the panels.

Turn car light on. Adjust brightness using remote control.

The last setting will be stored in EEPROM. The next time the car is turned on, the

brightness setting will be the same.