Required tools for installation of a V-1020C speaker with V-9914 bridge.

First, cut a pre-measured hole in the ceiling tile.

Using the bridge as a guide, determine the screw holes for the ceiling tile.

Align the speaker with the holes in the ceiling tile.

Align the speaker with the bridge on either side of the ceiling tile.

Attach all three pieces with the provided hardware.

Connect all wiring to the screw cages on the speaker.

Place the speaker assembly in the ceiling grid.

Lower the speaker assembly into position in the ceiling grid.

Insert the included volume control knob and adjust the speaker volume...

...or adjust the speaker volume with a flat blade screwdriver.