Removal Rear Doorpanels Seat Leon 1P (v2.0)

Step 1 – Removal parts.

Start with the removal of the three separate parts on the doorpanel.

- Clothing : Just pull it off. Start at the most left side and use a big flat-head screwdriver of wedge

to click the clothing off. Unhook the cable which controls the lock.

- Grip : Start at the most right side. If you remove the clothing first you will see an opening in

which you can put a flathead screwdriver. Click the grip off gently.

- Speaker cover : Remove by using a big flathead screwdriver. Just pull it off.

Step 2 – Remove the speaker (original of aftermarket)

Remove the speaker from the compartment.

Step 3 – Fixate the window

Use good tape to fixate the window. Because the up-down-mechanism will be removed of the door it is

necessary to keep the window in its place.

Step 4 – Disconnect window mechanism

Loosen the two screws which are holding the window. Do not remove them completely! Power up the

car and use the window-down button to lower the mechanism. The window should be hanging onto the

tape. Lower it to about halfway down.

Step 5 – Remove al the screws

Remove al the screws which are holding the door panel to the door. When all the screws are removed

you can lift the panel up and out. The panel is hooked onto the door itself. Be careful with the wires

running behind the panel. They are clipped into little hooks. The can easily be removed but remove the

panel gently. No connecters need to be disconnected. You can put the panel aside in the car.

Step 6 - Putting it back together…

Just do everything in reversed order. Remember to put the wires back in their original clips ! When fixing

the window onto the up-down mechanism look at the marks on the glass were the original fixation was

done. Before closing the doorpanel make sure to test the up-down mechanism of the window !

Additional Info:

Tools needed:

- Torx 30 screwdriver

- Flathead screwdriver or wedge

- Tape

- Tools to remove the speaker

Time:

- Removal panel : 30 minutes

- All can be done by one person.

ETKA Drawings: