redmax su-o quick install
DESCRIPTION
RedMAX SU-O Quick InstallTRANSCRIPT
-
5/25/2018 RedMAX SU-O Quick Install
1/12
70-00067-01-02 Proprietary Redline Comm. 2010 Page 1 of 12 October 9, 2008
SU-OSubscriber
Outdoors
Quick Install Guide
-
5/25/2018 RedMAX SU-O Quick Install
2/12
SU-O Quick Install Guide
70-00067-01-02 Proprietary Redline Comm. 2010 Page 2 of 12 October 9, 2008
Copyright Information
All rights reserved October 9, 2008. The information in this document isproprietary to Redline Communications Inc. This document may not in wholeor in part be copied, reproduced, or reduced to any medium without priorconsent, in writing, from Redline Communications Incorporated.
Contact Information:
Redline Communications Inc.
302 Town Centre Blvd. Suite 100
Markham, ONCanada L3R 0E8
Web site:
http://www.redlinecommunications.com
Email:
Inquiries:[email protected]: [email protected]: [email protected]:[email protected]:[email protected]:[email protected]
Document Control:
70-00067-01-03-RedMAX_Subscriber_Outdoor_SU-O_Quick_Install-20100723a.doc
Disclaimer
The statements, configurations, technical data, and recommendations in thisdocument are believed to be accurate and reliable, but are presented withoutexpress or implied warranty. Additionally, Redline makes no representationsor warranties, either expressed or implied, regarding the contents of thisproduct. Redline Communications shall not be liable for any misuseregarding this product. The information in this document is subject to changewithout notice. No part of this document shall be deemed to be part of anywarranty or contract unless specifically referenced to be part of suchwarranty or contract within this document.
Software Versions
This user manual describes PTP operation using software release v4.xx, andPMP operation using software release v13.xx, and may include references orfeatures that are different or unavailable in previous software releases (referto product release notes).
http://www.redlinecommunications.com/http://www.redlinecommunications.com/mailto:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]:[email protected]://www.redlinecommunications.com/ -
5/25/2018 RedMAX SU-O Quick Install
3/12
SU-O Quick Install Guide
70-00067-01-02 Proprietary Redline Comm. 2010 Page 3 of 12 October 9, 2008
Table of Contents
1 Safety Notices ................................................................... 32 Introduction ....................................................................... 43 Installation Procedure ...................................................... 43.1 Unpack SU-O Components ......................................... 53.2 Install the SU-O ............................................................ 53.3 Connect Outdoor Cable to SU-O ................................. 53.4 Connect the SU-O to the PoE Adapter ........................ 63.5 Connect Local Network Device .................................... 73.6 Power-On the SU-O ..................................................... 83.7 Configure SU-O and Align Antenna ............................. 8
11 SSaaffeettyyNNoottiicceessModels SU-OIA and SU-ORF Outdoor Modems (SU-O):
- Outdoor unit must not be installed near power lines or other
electrical power circuits.- Outdoor units must be properly grounded to protect against power
surges and accumulated static electricity.- It is the user's responsibility to install this device in accordance
with the local electrical codes: grounding of the transceiver unit,mast, lead-in wire and discharge unit, location of discharge unit,size of grounding conductors and connection requirements forgrounding electrodes.
- Do not place the indoor PoE equipment on or near a direct heat
source or operate near water or wet location.- Do not exceed the limits described on product labels.- Position power cords to avoid damage; do not overload wall
outlets and use only properly grounded power receptacles.- Disconnect power before cleaning and use only a damp cloth for
cleaning. Do not use liquid or aerosol cleaners.- Disconnect power when product is not in use.- Refer to the Subscriber User Manual (70-00057-01) for additional
safety notices and regulatory information.
-
5/25/2018 RedMAX SU-O Quick Install
4/12
SU-O Quick Install Guide
70-00067-01-02 Proprietary Redline Comm. 2010 Page 4 of 12 October 9, 2008
22 IInnttrroodduuccttiioonnThe SU-O is a fully integrated WiMAX Forum Certified subscriber
unit incorporating an Ethernet interface and wireless interface to aWiMAX base station. The subscriber is available with integratedantenna or a selection of external antennas. Mounting options areavailable to accommodate pole and wall mount.
33 IInnssttaallllaattiioonnPPrroocceedduurreeUse the steps outlined in the following sections to assemble andcommission the SU-O:
1. Unpack all SU-O components.
2. Install the SU-O equipment, orienting the SU-O (or externalantenna) in a vertical or horizontal orientation as required.
3. Connect the SU-O to the PoE adapter.
4. Connect the local network device (PC, router, etc) to the PoE.
5. Power-on to configure the SU-O and adjust the antenna asrequired.
,
Figure 1: SU-OIA System Features
-
5/25/2018 RedMAX SU-O Quick Install
5/12
SU-O Quick Install Guide
70-00067-01-02 Proprietary Redline Comm. 2010 Page 5 of 12 October 9, 2008
3.1 Unpack SU-O Components
The following components are supplied with each SU-O:
- SU-OIA equipped with integrated antenna, or SU-ORF equippedwith antenna, antenna bracket, and RF cable.
- Outdoor Ethernet cable- Auto-sensing 110-240 VAC PoE adapter (indoor use only)- Lightning protection equipment (optional)