quick start guide - philips · quick start guide remote control pull out the plastic pro-tective...
TRANSCRIPT
MCM772
What�s in the Box?You should Þ nd these items upon opening the box.
FM antenna
Quick Start Guide
Remote Control
Pull out the plastic pro-tective sheet before use.
Quick Start Guide Power cordUser Manual
Control cable
MCM772_QSG_Eng.indd 1MCM772_QSG_Eng.indd 1 2008-9-22 10:47:362008-9-22 10:47:36
1
2
3
4
In standby mode, press and hold CLOCK on the remote control.
When the hour digits ß ash, turn VOLUME on the system or press VOL+/- on the remote control to set the hours.
Press CLOCK again and the minute digits ß ash. Then turn VOLUME on the system or press VOL+/- on the remote control to set the minutes.
Press CLOCK again to conÞ rm the time setting.
1
2
3
Speaker(right) Speaker
(left)
FM antenna
AC power
Setting the clockIMPORTANT! � To set clock in the Eco Power mode, press and hold STANDBY-ON 2 on the set for 3 seconds or more to switch to normal standby mode Þ rst before proceeding with the procedures below.
Tip See the User Manual for how to connect other equipment to this system.
4
Connect the speaker cables.
Connect the control cable.
Connect the FM antenna.
Connect the power cord of the system.
1
2
3
4
MCM772_QSG_Eng.indd 2MCM772_QSG_Eng.indd 2 2008-9-22 10:47:372008-9-22 10:47:37
4
3
2
1Playing a disc
Press SOURCE on the front panel to select DISC or press CD on the remote control.
Press ç to open the CD compartment.
Insert a disc with the printed side facing up. Press ç again to close the compartment.
Playback will start automatically. If not, press ÉÅ.
To stop playback, press 9 .
5
1
2
3
Insert the USB device�s USB plug into the socket on the set.
Press SOURCE once or more (or USB on the remote control) to select USB.
Play the USB�s audio Þ les as you do with the albums/tracks on a CD.
Playing a USB mass storage device With the Hi-Fi system, you can use USB ß ash memory (USB 2.0 or USB1.1), USB ß ash players (USB 2.0 or USB1.1), memory cards (requires an additional card reader to work with this Hi-Fi system).
CD
MCM772_QSG_Eng.indd 3MCM772_QSG_Eng.indd 3 2008-9-22 10:47:382008-9-22 10:47:38
1
2
3
Press SOURCE (FM on the remote control) to select tuner source.
Press PROG on the remote control for more than two seconds to program all available sta-tions in order of waveband.
Press ¡ / ™ until the desired preset station is displayed.
Programming and tuning to radio stations
PDCC-JS-WP-0829
Tip Detailed playback features and additional functions are described in the accompany owner's manual.
C Royal Philips Electronics N.V. 2008All rights reserved.
http://www.philips.com
MCM772_QSG_Eng.indd 4MCM772_QSG_Eng.indd 4 2008-9-22 10:47:392008-9-22 10:47:39