Pulse X1 User Guide - v01.3.Mar2018 Page - 2 -

Accessory Receptacle

Timer Display

On/Off Switch(FRONT of Pulse X1)

Start/Pause Button(To start or pause a session)

Magnetic Field Strength Dial (MFS)

Pulse X1 User Guide - v01.3.Mar2018 Page - 3 -

Please Read All Cautions & Reminders Before Proceeding

Fault Mode is a safety feature. When in fault mode, the X1’s lights will go out. This can happen if you pull an accessory cable out of the machine while the machine is active. If a fault happens: Hold the START button for 3 seconds and the machine should reset.

Folding handle must be in down position to plug in accessory.

• Do not use the Pulse X1 with any implanted electronic device, which may include pacemakers, defibrillators, cochlear hearing devices, or insulin pumps.

• Remove all the following from your person: Electronic or battery operated devices, keys, credit cards, jewelry, or hearing aids.

• Do not use the Pulse X1 while pregnant.

• Do not use while actively bleeding, hemorrhaging, or during heavy menstruation.

• If you are unsure of other issues, consult your doctor.

• If you find yourself holding your breath or tensing up with every pulse, the intensity is too high and the session could result in discomfort later. Each User should adjust the intensity to a comfortably strong level.

Precautions

STOP

DO NOT run multiple Pulse machines at the same time on the same person or you could destroy electronic components in your Pulse system.

The magnetic field output from one accessory could be transferred through the accessory powered by a second machine and corrupt the electronics inside the machine.

Pulse X1 User Guide - v01.3.Mar2018 Page - 4 -

How to START a Charging SessionFirst refer to “What to Remove Before a Charging Session”

1. Plug the power cord into wall outlet and turn power on with green switch.

2. Insert accessory into Accessory Receptacle(s) above Magnetic Field Strength dial and make sure Magnetic Field Strength dial is turned all the way to the left.

3. Place accessories on desired area or areas. For example: Lie or sit on Chair Pad or Total Body Bed and place 10” Paddles or 6” Rings on the desired area.

4. Press the START button.

5. Turn up intensity to desired setting.

Important Notes to Remember

• Turn the MFS up until you are relaxed with the pulsing.

• If using two accessories, plugs must be inserted into the Pulse X1 facing the same direction.

• Plug desired body-application accessory into the Accessory Receptacle(s). Ensure all Accessory Receptacles are filled; use Dummy Plug if necessary.

• When using two accessories, the power of the MFS is divided equally (50% in each accessory).

• Ensure the MFS dial is turned all the way to the left before starting every session.

Adjusting Time and Magnetic Field Strength (MFS) • Adjust time of session by pushing/holding the START button. * The time

increases in 2 minute increments, up to 20 minutes. After 20 minutes, the time increases by 10 minutes.

• Listen to the ticking sound. It will be rapid at first - this indicates lower magnetic field strength and higher pulsation. As you turn the dial clockwise, the magnetic field strength increases as the ticking (pulsing) speed decreases.

• To decrease MFS, turn the dial counter-clockwise.

DO NOT PULL OUT ACCESSORIES WHILE CHARGING SESSION IS IN PROGRESS!

Please Note: Cables should always face the same direction.