production technology ch31
TRANSCRIPT
-
7/31/2019 Production technology Ch31
1/9
Kalpakjian SchmidManufacturing Engineering and Technology 2001 Prentice-Hall Page 31-1
CHAPTER 31
Surfaces: Their Nature, Roughness, andMeasurement
-
7/31/2019 Production technology Ch31
2/9
Kalpakjian SchmidManufacturing Engineering and Technology 2001 Prentice-Hall Page 31-2
Surface Structure of Metals
Figure 31.1 Schematic illustration of a cross-section of the surface structure of metals. The thickness of theindividual layers is dependent on processing conditions and processing environment.
-
7/31/2019 Production technology Ch31
3/9
Kalpakjian SchmidManufacturing Engineering and Technology 2001 Prentice-Hall Page 31-3
Fatigue Curve for Surface-Ground Steel
Figure 31.2 Fatigue curve forsurface-ground 4340 steel, quenchedand tempered, 51 HRC. Note the
severe reduction in fatigue strengthunder abusive grinding conditions.(See also Fig. 2.28.)
-
7/31/2019 Production technology Ch31
4/9
Kalpakjian SchmidManufacturing Engineering and Technology 2001 Prentice-Hall Page 31-4
Terminology in Describing Surface Finish
Figure 31.3 Standardterminology andsymbols to describe
surface finish. Thequantities are given in in.
-
7/31/2019 Production technology Ch31
5/9
Kalpakjian SchmidManufacturing Engineering and Technology 2001 Prentice-Hall Page 31-5
Coordinates for Surface-RoughnessMeasurements
Figure 31.4 Coordinates used for surface-roughness measurement, using Eqs. (31.1) and (31.2).
-
7/31/2019 Production technology Ch31
6/9
Kalpakjian SchmidManufacturing Engineering and Technology 2001 Prentice-Hall Page 31-6
Standard Lay Symbols for Engineering
Surfaces
Figure 31.5
-
7/31/2019 Production technology Ch31
7/9
Kalpakjian SchmidManufacturing Engineering and Technology 2001 Prentice-Hall Page 31-7
Measuring Surface Roughness
Figure 31.6 (a) Measuring surface roughness with a stylus. The rider supports the stylus and guards againstdamage. (b) Surface measuring instrument. Source: Sheffield Measurement Division of Warner & Swasey Co.(c) Path of stylus in surface roughness measurements (broken line) compared to actual roughness profile. Notethat the profile of the stylus path is smoother than that of the actual surface. Source: D. H. Buckley
(b)
-
7/31/2019 Production technology Ch31
8/9
Kalpakjian SchmidManufacturing Engineering and Technology 2001 Prentice-Hall Page 31-8
Surface Profiles
Figure 31.7 Typical surface profiles produced by various machining and surface-finishing processes. Notethe difference between the vertical and horizontal scales. See also Fig. 32.4. Source: D. B Dallas (ed.),Tools and Manufacturing Engineers Handbook, 3d ed. Copyright 1976, McGraw-Hill Publishing
Company. Used with permission.
-
7/31/2019 Production technology Ch31
9/9
Kalpakjian SchmidManufacturing Engineering and Technology 2001 Prentice-Hall Page 31-9
Three-Dimensional Surface Measurement
Figure 31.8 Surface of rolled aluminum.
Figure 31.9 A highly polished siliconsurface measured in an atomic forcemicroscope. The surface roughness isRq = 0.134 nm.