presented by: hermann kamphues klaus zimmer€¦ · compax3 s/m/h/f with ethercat ethercat profil:...
TRANSCRIPT
Presented by:
Hermann Kamphues
Klaus Zimmer
Compax3 with EtherCAT
Agenda:
� Overview
� Settings for Compax3
� Operation modes DS402
AgendaAgenda
� Operation modes DS402
� XML-Files
� Available EtherCAT Masters
� Application examples
2
• EtherCat option for EME Drives
• Ethernet based Real Time Communication
• CAN over EtherCat (CoE) Protocol
• Beckhoff master and also other suppliers
• SLVD-N EtherCat
Electromechanical Division Europe
• SLVD-N EtherCat
• SLVD-N EtherCat option
• Launched
• C3 EtherCat
• C3 EtherCat option card (I31)
3
Compax3 S/M/H/F with EtherCat
EtherCat
� Profil: Motion Control CiADS402� Profil: Motion Control CiADS402
� 100 Mbits (Fast Ethernet)
(Launch done 2008)
4
viewC3 I31 EtherCAT
5
viewC3 I31 EtherCAT
6
������������� ����
7
���
8
���Object 6060h: Modes of operation
This object shall indicate the requested operation mode.
NOTE This object shows only the value of the requested
operation mode, the actual operation mode of the PDS is
reflected in the object modes of operation display.
-128 to -1 Manufacturer-specific operation modes
0 No mode change/no mode assigned
+1 Profile position mode
+2 Velocity mode
+3 Profile velocity mode
+4 Torque profile mode
+5 Reserved
+6 Homing mode
+7 Interpolated position mode
+8 Cyclic sync position mode
+9 Cyclic sync velocity mode
+10 Cyclic sync torque mode
+11 to +127 Reserved
reflected in the object modes of operation display.
9
����
10
mappingC3 I31 EtherCAT
11
mapping C3 I31 EtherCAT
12
Settings for Compax3
13
Signal structureC3 I31 EtherCAT
14
mappingcommunication
PLC => C3PLC => C3
<- pointer!
15
Switch off: 819.3
mapping
PLC <= C3PLC <= C3
communication
16
Switch off : 819.4
<- pointer!
Synchronizations method
Selection of the synchronization method
the selection is made via object 820.24
PLL synchronization (Object 820.24 = 0)
During the PLL synchronization, the system
clock of the slave device is synchronized to the
system clock
Timestamp method (Object 820.24 = 1)
During the timestamp method, the slave is not
synchronized to the master clock.
17
Interpolation method
Setting the interpolation method via object 3925.1 (CANopen No.: 0x60C0.0)
� 0=linear Interpolation (Default)
�-1=linear Interpolation
�-2=Quadratic Interpolation �-2=Quadratic Interpolation
�-3=Cubical (Spline-) Interpolation
18
Interpolationmode
19
Interpolationmode
20
Interpolationmode
21
C3 I31 EtherCAT link
C3 I31 T11 EtherCat
Application_Compax3_controlled_TwinCAT_v09_eng.pdf
22