powerflex 520-series communication adapters
TRANSCRIPT
Installation Instructions
PowerFlex 520-Series Communication AdaptersCatalog Numbers: 25-COMM-D, 25-COMM-P, 25-COMM-E2P
DeviceNet25-COMM-D
PROFIBUS DP25-COMM-P
EtherNet/IP Dual Port25-COMM-E2P
Interface connector for all communcation adapters
1 L1 L2 L3
O
I 2DC+ DC–
0V
0VWait three minutes after shutdown for capacitors to discharge to safe voltage levels.
3 Install the Communication Adapter Interface ConnectorFor PowerFlex 525For PowerFlex 523
Publication 520COM-IN001C-EN-P - July 2014
PowerFlex 520-Series Communication Adapters
54321
RedWhiteBareBlueBlack
4
5
Terminal Color Signal Function5 Red V+ Power Supply4 White CAN_H Signal High3 Bare SHIELD Shield2 Blue CAN_L Signal Low1 Black V- Common
Maximum Wire Size Minimum Wire Size Torque
3.33 mm2 (12 AWG) 0.08 mm2 (28 AWG) 0.44...0.54 Nm (3.9...4.8 lb-in)
Wiring the DeviceNet Adapter How to Remove the Control Module Back Cover if Required
25-COMM-D25-COMM-P25-COMM-E2P
Install the Communication AdapterDeviceNet adapter with optional 25-ENC-1 Incremental Encoder Input shown
Communication adapter label (pre-attached)
Space for optional Incremental Encoder Input label
Note: Incremental Encoder Input is for PowerFlex 525 only.You can install both the communication adapter and optional Incremental Encoder Input on the same Control Module Back Cover.
Publication 520COM-IN001C-EN-P - July 2014Supersedes Publication 520COM-IN001B-EN-P - September 2013 Copyright © 2014 Rockwell Automation, Inc. All rights reserved.
Allen-Bradley, Rockwell Software, Rockwell Automation, PowerFlex, and TechConnect are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
U.S. Allen-Bradley Drives Technical Support - Tel: (1) 262.512.8176, Fax: (1) 262.512.2222, E-mail: [email protected]: www.ab.com/support/abdrives