power quality.ppt
DESCRIPTION
Injection of the wind power into an electric grid affects the power quality. The performance of the wind turbine and thereby power quality are determined on the basis of measurements and the norms followed according to the guideline specified in International Electro-technical Commission standard, IEC-61400. The influence of the wind turbine in the grid system concerning the power quality measurements are-the active power, reactive power, variation of voltage, flicker, harmonics, and electrical behavior of switching operation and these are measured according to national/international guidelines. The paper study demonstrates the power quality problem due to installation of wind turbine with the grid. In this proposed scheme STATic COMpensator (STATCOM) is connected at a point of common coupling with a battery energy storage system (BESS) to mitigate the power quality issues. The battery energy storage is integrated to sustain the real power source under fluctuating wind power. The STATCOM control scheme for the grid connected wind energy generation system for power quality improvement is simulated using MATLAB/SIMULINK in power system block set. The effectiveness of the proposed scheme relives the main supply source from the reactive power demand of the load and the induction generator. The development of the grid co-ordination rule and the scheme for improvement in power quality norms as per IEC-standard on the grid has been presented.TRANSCRIPT
![Page 1: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/1.jpg)
STATCOM CONTROL SCHEME FOR GRID-CONNECTED WIND ENERY SYSTEM FOR POWER QUALITY IMPROVEMENT
UNDER THE GUIDENCE OF Mrs. M. KIRAN JYOTHI
BY
B.BALA KRISHNA
P.VARSHINI
P.N.S.V.MADHAV
P.SRINIVAS
![Page 2: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/2.jpg)
Injection of the wind power into an electric grid affects the power quality.
The performance of the wind turbine and thereby power quality are determined on
the basis of measurements and the norms followed according to the guideline
specified in International Electro-technical Commission standard,IEC-61400. The
influence of the wind turbine in the grid system concerning the power quality
measurements are measured according to national/international guidelines.
In this proposed scheme Static Compensator (STATCOM) is connected at a
point of common coupling with a battery energy storage system (BESS) to
mitigate the power quality issues. The battery energy storage is integrated to
sustain the real power source under fluctuating wind power.
ABSTRACT
![Page 3: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/3.jpg)
Injecting Wind Power into Grid & Improve the Power
Quality.
OBJECTIVE OF THE PROJECT
![Page 4: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/4.jpg)
BLOCK DIAGRAM
![Page 5: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/5.jpg)
FACTS
STATCOM
BESS.
WIND ENERGY GENERATING SYSTEM
COMPONENTS USED IN THE SCHEME
![Page 6: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/6.jpg)
It is a system composed of static equipment.
Used to enhance controllability and increase power transfer capability."
FACTS
![Page 7: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/7.jpg)
It is a regulating device used on AC transmission networks.
It is based on a voltage-source converter.
It acts in either capacitive or inductive mode
STATCOM
![Page 8: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/8.jpg)
WIND ENERGY GENERATING SYSTEM
Load
kinetic Energy
Mechanical Energy
Electrical Energy
![Page 9: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/9.jpg)
TYPES OF WIND TURBINES
VAWT
HAWT have the main rotor shaft and generator at the top of a tower and must be pointed into the wind.
VAWT have the main rotor shaft arranged vertically .The generator and gear box placed near the ground.
![Page 10: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/10.jpg)
It is used for the purpose of voltage regulation.
It can be used to level the power fluctuation by charging and discharging operation.
It rapidly injects or absorbed reactive power to stabilize the grid system.
BATTERY ENERGY STORAGE SYSTEM
![Page 11: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/11.jpg)
Without the proper power, an electrical device may malfunction, not operate at all.
Power quality determines the fitness of electrical power to consumer devices.
Synchronization of the voltage frequency and phase allows electrical systems to function properly.
POWER QUALITY
![Page 12: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/12.jpg)
Voltage variation
Harmonics
Reactive power
Wind turbine location in power system.
POWER QUALITY ISSUES
![Page 13: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/13.jpg)
SIMULATION DIAGRAM
![Page 14: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/14.jpg)
It is based on injecting the currents into the grid using “bang-bang controller.”
The controller uses a hysteresis current controlled technique.
The controller keeps the control system variable between boundaries of hysteresis area.
It gives correct switching signals for STATCOM operation.
CONTROL SCHEME
![Page 15: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/15.jpg)
SIMULATION RESULTS
Switching signal within a control hysteresis band
o The three phase injected current into the grid from STATCOM will cancel out the distortion caused by the nonlinear load and wind generator.
o The generation of switching signals from reference current is simulated within hysteresis band of 0.08..
![Page 16: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/16.jpg)
CONTINUE..
The performance of the system is measured by switching the STATCOM at time 0.7s in the system and how the STATCOM responds to the step change command for increase in additional load at 1.0 s is shown in the simulation.
Performance of STATCOM under load variations
![Page 17: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/17.jpg)
CONT.....
Three phase injected inverter Current
The compensated current for the nonlinear load and demanded reactive power is provided by the inverter.
The real power transfer from the batteries is also supported by the controller of this inverter.
![Page 18: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/18.jpg)
CONT.....
Supply Voltage and Current at PCC.
The source current with and without STATCOM operation is shown in Fig.
The unity power factor is maintained for the source power when the STATCOM is in operation.
![Page 19: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/19.jpg)
CONT…..
(a) DC link voltage. (b) Current through Capacitor.
The DC link voltage regulates the source current in the grid System.
The DC link voltage is maintained constant across thecapacitor as shown in Fig.
![Page 20: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/20.jpg)
CONT…..
It is observed that the source current on the grid is affected due to the effects of nonlinear load and wind generator.
Thus purity of waveform may be lost on both sides in the system.
![Page 21: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/21.jpg)
The power quality issues and its consequences are presented.
STATCOM has a capability to cancel out the harmonic parts of the load current.
STATCOM maintains the source voltage and current in-
phase and support the reactive power demand for the wind generator and load at PCC.
Thus the proposed scheme fulfills the power quality norms as per the IEC standard 61400-21.
CONCLUSION
![Page 22: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/22.jpg)
Power system voltage control applications.
Large electric arc furnace installations.
Reactive power compensation applications.
Railway or underground systems with huge load variations
APPLICATIONS
![Page 23: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/23.jpg)
STATCOM can be replaced with UPQC for better power control.
Replacing the induction generator with doubly fed induction generator is preferred for better results.
In future the off-shore wind turbines will be implemented due to its advantages of producing high power.
FUTURE SCOPE
![Page 24: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/24.jpg)
![Page 25: Power quality.ppt](https://reader035.vdocuments.us/reader035/viewer/2022081602/556412aad8b42a080c8b52d0/html5/thumbnails/25.jpg)