porcupine technical data - armortec · it is important to get the foundation surface level as any...
TRANSCRIPT
PORCUPINE
Porcupine
Porcupine
Porcupine
Porcupine’s
Porcupine
Porcupine
A simple to build multi-variable retaining wallsystem from Armortec
™E r o s i o n C o n t r o l S o l u t i o n s
PORCUPINE is undoubtedly the most versatile and economicsolution for effective and visually appealing retaining walls
Porcupine
150mm
200mm
330mm
T E C H N I C A L D E T A I L S
The Porcupine block
CONCRETE SPECIFICATION
DESIGN SERVICE
DIMENSIONS MARK II BLOCK
It is important to get the foundation surface level asany irregularity will show in the finished wall.
InstallationThe lower block should always be placed horizontallyon the foundation so that the flat face is vertical tothe rear.
The top splines should bebrushed clean on everyblock before laying the nextblock on top.
Bends and Curves
Installation Instructions
820mm approx.
Foundation
TYPICAL DETAILSMark III Porcupine
FIG 1
Flat Face
1. Dig Trench
2. Install to a levelline temporaryshutters
3. Pour concrete,trowel to asmooth levelsurface andinsert dowelbars
4. Lay first row ofblocks andplace concretechamfer overdowel bars
Round Face
330mmwide
Steeldowel
Concretechamfer
Temporaryshutters
200mm long 10mmØ dowel barsat 0.5m centres
FIG 2
FIG 3
GL
GL GL
GL
Sikadur 31
Technical Data:
TYPICAL WALLS
FIG 4 Vertical Wall FIG 5 7.5° Wall (82.5°from horizontal)
FIG 6 15° Wall (75° fromhorizontal)
FIG 7 22.5° Wall (67.5° fromhorizontal)
7.5°
22.5°
15°
7.5°7.5°
15°
A random surface tothe face of the wallcan be achieved byusing our split facePorcupine blocks.
FIG 9
Securing ofPorcupine Coping Block
FIG 10
FIG 8
Split Face Blocks
Coloured Blocks
Design ServiceWe offer clients a “Design Suggestion Service” for Porcupine retaining walls.
Using our dedicated computer program, we will incorporate customer’sspecific construction parameters to ensure that the required factors of safetycan be achieved if construction work is carried out correctly.
Our design suggestion service, which complies with BS8006,does not constitute or imply an indemnified design.
RPC Ltd
™E r o s i o n C o n t r o l S o l u t i o n s