please follow instructions for ease of assembly c. …€¦ · 31/01/2012 · 11. a)...
TRANSCRIPT
11.
a) Unfold--Unfold and Expand Outer Box
d) Construct Top--Fold 3 Single Panels to InsideAgainst Box Sides
Section 1 Partition Assembly
1) Start on Flat Surface @BEGIN HERE--SECTION 1 --WHITE SIDE UP
4) With Panel Labeled “TOP” Up,Fold Panel with Instruction #4DOWN. Locking bottom is notnecessary at this time.
5) Fold Panel with Instruction #5UP--Panel Labeled “BOTTOM” isHeld Down. Insert TAB C IntoSLOT C and TAB D Into SLOT D.
6) With Panel Labeled “TOP” up,Fold Panel with Instruction #6DOWN.
Flip Over BROWN SIDE UP--Insert remaining 4 UNMARKEDTABS into adjacent SLOTS--Set Aside for Later Assembly--
7.
8.
b) Construct Bottom.--Fold Single Panel Flush withBottom
c) Fold Panel with 2 Tabs OverBottom. Insert End Tabs in Slots.
13. Flip Both SECTIONSWHITE SIDE UP
e) Insert Truss Partition into BoxAs Shown--WHITE SIDETOWARD PRINTED TOP.(Tabs Inside Box “Lock” inPlace When Partition Inserted)
2) Fold First Panel UP--PanelLabeled “BOTTOM” is HeldDown.
AssemblyInstructionsThe “TrussFile”
TrussFile--Assembled(2 TrussFile25’s Shown)
A.
AOSDVANCED
RGANIZINGYSTEMS, INC.www.aosystems.com
3) Fold Panel with Instruction #3UP. Insert TAB A Into SLOT Aand TAB B Into SLOT B.
Section 2 Partition Assembly(Similar to Section 1 Assembly)
7) Start on Flat Surface @BEGIN HERE--SECTION 2 --WHITE SIDE UP
8) Fold First Panel UP--PanelLabeled “BOTTOM” is HeldDown.
B.
9) Fold Panel with Instruction #9UP. Insert TAB E Into SLOT Eand TAB F Into SLOT F.
10) With Panel Labeled “TOP” Up,Fold Panel with Instruction #10DOWN. Locking bottom is notnecessary at this time.
11) Fold Panel with Instruction #11UP--Panel Labeled “BOTTOM” isHeld Down. Insert TAB G IntoSLOT G and TAB H Into SLOT H.
12) With Panel Labeled “TOP” up,Fold Panel with Instruction #12DOWN.
Flip Over BROWN SIDE UP--Insert remaining 4 UNMARKEDTABS into adjacent SLOTS--See Step C. to Join Sections--
Join Partitions -- Sections 1 & 2C.
Join Sections by Inserting TabsI,J,K & L Into CorrespondingSlots I,J,K&L.
FINSHED TRUSS ASSEMBLYSet Aside for Later Insertion inOuter Box.
Construct Box & Insert TrussD.
PARTS LIST per TrussFile 1 ea. -- SECTION 1 Partition 1 ea. -- SECTION 2 Partition 1 ea. -- Outer Box
1.
2.3.
4.
5.
6.
8.9.
10. 12.
13.
a.
PLEASE FOLLOW INSTRUCTIONS FOR EASE OF ASSEMBLY
Instructions TrussFile001.p65--31Oct2005
Note: For easyclosure whenstacked,Slant Top Inward.
Flip Section 1 OverBrown Side Up
Flip Section 2 OverBrown Side Up
b.
c.
d.
e.