performance and emission analysis of dtsi engine
TRANSCRIPT
![Page 1: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/1.jpg)
Department of Mechanical EngineeringPimpri Chinchwad College of Engineering
Performance and Emission Analysis of DTS-I Engine
Presented By :
SAGAR DHUMAL
(TEME B)
Guided By :
Mr. S. S. MORE
![Page 2: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/2.jpg)
WHAT IS DTS-I TECHNOLOGY ?
![Page 3: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/3.jpg)
Combustion with and without using DTS-I Technology
![Page 4: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/4.jpg)
Advancement in DTSI Technology
• Digital Twin Spark – Swirl Induction (DTS - SI)• Digital Twin Spark – Fuel Injection (DTS - FI)• Digital Triple Spark Ignition (DTSI)• Intelligent CDI• TRICS III (3RD GENERATION)• Advancement in Bike Cooling System• ExhausTEC
![Page 5: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/5.jpg)
Digital Twin Spark – Swirl Induction (DTS - SI)
• The Swirl Induction concept, which is meant for producing higher turbulence in the combustion chamber.
• This can be done by making slight modifications in the ports positioning of engine.
![Page 6: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/6.jpg)
DTS-I Triple Spark Engine
• Engine has 3 spark plugs in the combustion chamber. the primary plug is at centre at an angle and other two secondary plugs are mounted below, each opposite to each other.
• The secondary plugs fires a bit after the primary one has fired and the timings are controlled by the ECU depending on throttle position, engine rev, load on engine.
![Page 7: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/7.jpg)
Digital Twin Spark-Fuel Injection (DTS-FI)
• In fuel injection the conventional carburettor
has been replaced by injector which injects fuel in to the engine in a spray form based on the instructions of the Engine Control Unit (ECU) .
• ECU processes information sent by various sensors and instantly determines optimum fuelling and spark timing for various engine operating conditions.
![Page 8: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/8.jpg)
Intelligent CDI (Capacitor Discharge Ignition)
• It contains a microprocessor, which continuously senses different speeds and load on engine and responds by altering ignition timing.
• Working together with the TRICSIII system, the microprocessor’s memory provides optimum ignition timings for any given engine rpm.
![Page 9: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/9.jpg)
TRICS III (3RD GENERATION)
• TRICS III stand for Throttle Response Ignition Control System III Generation.• Depending on the needs of the rider whether it be cruising, acceleration or max speed, the
ignition requirements constantly change.• Based on a particular amount of throttle opening, the magnetic field generated by the
magnet opens or closes the reed switch. The reed switch is connected to the Digital C.D.I., which signals the C.D.I. to change / switch, the desired ignition advance timing maps.
![Page 10: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/10.jpg)
Advancement in Bike Cooling System
• Bajaj Pulsar 200 NS has liquid cooled engine
• Heart of this system is radiator and blood of the system is the coolant or liquid which circulates through the channels made just outside of the cylinder wall to absorb the heat and comes back to radiator to cool down.
• Motul Moto Cool expert or Castrol Radicool is used is coolant.
![Page 11: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/11.jpg)
ExhausTEC
• ExhausTEC is a device incorporated in the exhaust system.
• TEC stands for ‘Torque Expansion Chamber’. It is a tuned box (resonator) fitted onto the header pipe of the exhaust.
• In the lower rpm zones, the ExhausTEC helps to build a negative pressure pulse (vacuum) at the exhaust valve, thereby sucking in more air-fuel mixture into the cylinder during intake valve opening
![Page 12: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/12.jpg)
“Performance and emission Analysis of DTS-I
Engine and single Spark engine
1. Brake thermal efficiency v/s load 2. Brake specific fuel consumption v/s load 3. Volumetric Efficiency v/s Load 4. Detonation5. Unburnt Hydrocarbon emission vs load6. Co Emission v/s load7. NOx Emission v/s load
![Page 13: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/13.jpg)
Experimental Setup
Maker’s name Hero MotoCorp Bajaj auto limited Bajaj auto limited
Model type Hunk pulsar 150 DTS-I Pulsar 200 NS
Type of engine Four stroke single cylinder, air cooled engine
Four stroke single cylinder, air cooled engine
Four stroke single cylinder, water cooled engine
Displacement volume
149.2 cc 149.01 cc 199.5 cc
Compression ratio
9.1:1 9.5:1 11:01
Maximum power
13.1 Ps @8500 rpm 13.2 Ps @8500 rpm 23.5 Ps@9500 rpm
Maximum torque
12.80 Nm@6500 rpm 11.25 Nm@6500 rpm 18.3 Nm@8000 rpm
Ignition system CCVI I-CDI system I-CDI system
![Page 14: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/14.jpg)
Brake Specific Fuel Consumption V/S Load
• It is maximum for single spark engine and minimum for the triple spark engine.
![Page 15: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/15.jpg)
Volumetric Efficiency V/S Load
• Initially volumetric efficiency is maximum for single spark engine and minimum for triple spark engine.
• In all the cases it increases with the increase in the load.
![Page 16: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/16.jpg)
Unburnt Hydrocarbon Emmision Vs Load
• UBHC emissions are higher in single spark engine because of incomplete combustion.
• Triple spark engines have lesser and better UBHC emission due to better and faster completion of combustion.
![Page 17: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/17.jpg)
Co Emission V/S Load
• CO emissions are highest for the
single spark engine due to incomplete combustion.
• It is least for the triple spark engine. • CO emissions decrease with load in all
three conditions because at high temperature CO gets oxidized.
![Page 18: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/18.jpg)
NOx Emission v/s Load
• NOx emissions are higher for twin and triple Plug engine at initial conditions.
• Curve of triple plug engine tends to approach minimum value due to liquid cooling.
![Page 19: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/19.jpg)
Detonation in DTS-i Engine
• Detonation is the main problem in petrol engine.
• Detonation occurs when the flame travel time from centre to the
side walls increases.
• It happens often in the engines having single spark plug.
• This is overcome by the DTSI by having two spark source on the
opposite sides which reduces the flame travel as stated above.
Hence no detonation……
![Page 20: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/20.jpg)
Other Vehicle Manufacturer's That uses Twin spark Technology
TVS Motors (CC-VTI)
Royal Enfield
Honda (i-DSI)
Alfa Romeo
![Page 21: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/21.jpg)
Advantages and Disadvantages
![Page 22: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/22.jpg)
CONCLUSION….
![Page 23: performance and emission analysis of DTSI engine](https://reader036.vdocuments.us/reader036/viewer/2022081507/58edc3d31a28abe8168b4645/html5/thumbnails/23.jpg)
THANK YOU