OC

P&

E B

RA

ND

H2

S S

CA

VE

NG

ER

S

HYDROGEN SULFIDE SCAVENGERS ARE AMINE BASED CHEMICALS DESIGNED TO “SWEETEN" ACID GASES IN PIPELINE, CONFINED SPACE, AND PACKED BED WET SCRUBBER SYSTEMS. IN THE WET SCRUBBER SYSTEM, HYDROGEN SULFIDE SCAVENGERS REPLACE THE TRADITIONAL APPROACH OF USING SODIUM HYPOCHLORITE (BLEACH) AND SODIUM HYDROXIDE (CAUSTIC SODA).

SPECIALLY FORMULATED WITH ONE TO THREE AMINES INCLUDING TRIAZINE, MONOETHANOLAMINE, AND/OR METHYLDIETHANOLAMINE, OCP&E BRAND HYDROGEN SULFIDE SCAVENGERS ARE FORMULATED TO TACKLE THE TOUGHEST HYDROGEN SULFIDE AND METHYL MERCAPTAN LOADS. UNLIKE CAUSTIC SODA, THESE FULL STRENGTH CHEMICALS (63%-99% ACTIVE) CAN BE WINTERIZED WITH METHANOL TO PREVENT PLUGGING AND FREEZING IN COLD TEMPERATURES. FOR ADDED EFFICACY, HYDROGEN SULFIDE SCAVENGERS CAN BE MANUFACTURED WITH A BLEND OF LOW FOAMING SURFACTANTS AND SILICONE DEFOAMER.

THE PROPRIETARY SURFACTANT BLEND SCRUBS PACKING MEDIA, CLEANING OFF FATS, OILS, GREASES, AND SCUM. THE SURFACTANTS ALSO SOLUBILIZE, CAPTURE, AND EMULSIFY ODOROUS SPECIES INTO THE WATER PHASE, ALLOWING FOR FAR SUPERIOR MALODOR CONTROL THAN WITH TRADITIONAL OXIDIZERS WITHOUT CREATING THE SCALING WHICH OCCURS FROM BLEACH/CAUSTIC REACTIONS. ACID WASHING THE SCRUBBER SYSTEM BECOMES OBSOLETE. FURTHERMORE, OCP&E BRAND HYDROGEN SULFIDE SCAVENGERS DO NOT CREATE CHLORINATED BY-PRODUCTS IN THE AIR OR EXCESS SODIUM IN DEEP WELL INJECTION SITES. IN FACT, ALL BY-PRODUCTS FORMED ARE NON-HAZARDOUS AQUEOUS COMPOUNDS SUCH AS SULFONATED AMINES.

SCAVENGERS ARE METERED AND PUMPED INTO THE SCRUBBER SYSTEM VIA A 4-20 MILLIAMP CHEMICAL METERING PUMP. A CONTINUOUS EMISSIONS MONITORING (CEM) SYSTEM FOR HYDROGEN SULFIDE ACTUATES THE CHEMICAL METERING PUMP TO PRECISELY DOSE THE CHEMICAL, THEREBY ELIMINATING OVER AND UNDER-DOSING OF THE SCRUBBANT. OCP&E RECOMMENDS THE ODALOG� SYCAMORE SYSTEM WHERE STACK EXHAUST CAN BE PROGRAMMED AND CONTROLLED TO ACHIEVE A DESIRED SET-POINT OF SAY, 0.0 P.P.M. OR EVEN 0.0 P.P.B.

IN MULTI-STAGE WET SCRUBBER SYSTEMS, SCAVENGERS REMOVE THE MAJORITY OF SULFIDES AND MERCAPTANS IN THE FIRST AND/OR SECOND STAGE OF THE SYSTEM, AND POLISHING AGENTS SUCH AS OCP&E BRAND PEROXIBASE I OR II OR OCP&E BRAND SCRUBBER FORMULA 2X REMOVE ANY REMAINING ODORS, INCLUDING THE SLIGHT CHARACTERISTIC AMMONIANICAL AMINE ODOR IN THE LAST OR FINAL SCRUBBER STAGE.

STARTING RECOMMENDATIONS WILL VARY DEPENDING ON THE ODOR LOAD. TYPICAL STARTING RECOMMENDATIONS FOR A 75,000 CFM SCRUBBER ARE AS FOLLOWS:

RENDERING PLANTS: 1-4 275 GALLON TOTES PER MONTH.WASTEWATER TREATMENT PLANTS: 1-4 275 GALLON TOTES PER MONTH.

HYDROGEN SULFIDE SCAVENGERS HAVE A PH OF 10.5 TO 12.5. TYPICAL WEIGHT PER GALLON IS 8.91 LBS. SPECIFIC GRAVITY IS 1.11 TO 1.13. CHEMICAL IS WATER SOLUBLE. ALWAYS REFER TO MATERIAL SAFETY DATA SHEET (M.S.D.S.) BEFORE HANDLING THIS PRODUCT. NEVER MIX THIS CHEMICAL WITH STRONG OXIDIZING AGENTS AND/OR ACIDS.

TO FURTHER ASSIST YOU IN DETERMINING THE SUITABILITY OF THIS CHEMICAL, OCP&E PROVIDES ON-SITE BENCH TESTING, FIELD STUDIES, AND TECHNICAL SUPPORT. PLEASE CALL TO SCHEDULE A SITE VISIT.

©2011 OCP&E, LLC.--ALL RIGHTS RESERVED.�

www.ocpe.us

OC

P&

E B

RA

ND

PE

RO

XIB

AS

E I

& II PEROXIBASE IS SCIENTIFICALLY CREATED TO REPLACE OR AUGMENT CHLORINE DIOXIDE,

SODIUM HYPOCHLORITE (BLEACH), SODIUM HYDROXIDE (CAUSTIC SODA), AND ACIDS IN BOTH PACKED BED WET SCRUBBER SYSTEMS AND MIST CHAMBER SYSTEMS. PEROXIBASE IS PATENT PENDING.

SPECIALLY FORMULATED WITH FOUR PRIMARY INGREDIENTS CONSISTING OF A LEVEL I 8% OR A LEVEL II 12% HYDROGEN PEROXIDE BASE, PROPRIETARY CATIONIC SURFACTANT, BLOCK POLYMER SURFACTANT, AND A POLISHING AGENT OF CITRUS TERPENES (d-LIMONENE), OR PEROXIDE STABLE INDUSTRIAL GRADE DEODORIZER, PEROXIBASE OXIDIZES HYDROGEN SULFIDE, DESTROYS CERTAIN VOCS, CLEANS AND DISINFECTS PACKING MEDIA REMOVING FATS, OILS, AND GREASES (F.O.G.), AND ABSORBS REMAINING ODOROUS COMPOUNDS, IMPARTING A CLEAN, FRESH SCENT.

THE PROPRIETARY SURFACTANT BLEND SCRUBS PACKING MEDIA, CLEANING OFF FATS, OILS, GREASES, AND SCUM. THE SURFACTANTS ALSO SOLUBILIZE, CAPTURE, AND EMULSIFY ODOROUS SPECIES INTO THE WATER PHASE, ALLOWING FOR FAR SUPERIOR MALODOR CONTROL THAN WITH TRADITIONAL OXIDIZERS WITHOUT CREATING THE SCALING WHICH OCCURS FROM BLEACH/CAUSTIC REACTIONS. FURTHERMORE, PEROXIBASE DOES NOT CREATE CHLORINATED BY-PRODUCTS IN THE AIR OR EXCESS SODIUM IN DEEP WELL INJECTION SITES.

UNLIKE ALL OTHER OXIDIZERS, PEROXIBASE CONTAINS A POWERFUL AND PLEASANT ODOR CONTROL POLISHING AGENT OF D-LIMONENE OR PEROXIDE STABLE INDUSTRIAL DEODORIZER. CITRUS TERPENES, PROPRIETARY CHEMICALS, AND ESSENTIAL OILS ACT AS POWERFUL ODOR ABSORBERS AND SOLVENTS FOR ORGANIC ODORS. UNLIKE CHLORINATED COMPOUNDS OR OTHER CHEMICALS, PEROXIBASE'S CITRUS BLEND ERASES REMAINING ODORS. STACK EXHAUST SMELLS CLEAN AND FRESH, WITHOUT A "BLEACHY" OR CHEMICAL ODOR.

PEROXIBASE IS METERED AND PUMPED INTO THE SCRUBBER SYSTEM VIA A CHEMICAL METERING PUMP. TO AVOID FUGITIVE EMISSIONS, A CONTINUOUS EMISSIONS MONITORING (CEM) SYSTEM FOR HYDROGEN SULFIDE ACTUATES THE CHEMICAL METERING PUMP VIA 4-20 MILLIAMP SIGNAL OR PID CONTROLLER TO PRECISELY DOSE THE CHEMICAL, THEREBY ELIMINATING OVER AND UNDER-DOSING OF THE SCRUBBANT.

STARTING RECOMMENDATIONS WILL VARY DEPENDING ON THE ODOR LOAD. TYPICAL STARTING RECOMMENDATIONS FOR A 75,000 CFM SCRUBBER ARE AS FOLLOWS:

RENDERING PLANTS: 2-4 55 GALLON DRUMS PER MONTH.WASTEWATER TREATMENT PLANTS: 1-3 55 GALLON DRUMS PER MONTH. FOR MULTIPLE STAGE SYSTEMS, INJECT CHEMICAL INTO ALL TOWERS.

FOR THIS APPLICATION, INJECT THE CHEMICAL WITH A CHEMICAL METERING PUMP SET A 100% SPEED; STROKE WILL VARY DEPENDING ON THE APPLICATION. MAINTAIN 100% SPEED TO AVOID ANY WATER-PRODUCT GAP EFFECTS.

TO FURTHER ASSIST YOU IN DETERMINING THE SUITABILITY OF THIS CHEMICAL, OCP&E PROVIDES ON-SITE BENCH TESTING, FIELD STUDIES, AND TECHNICAL SUPPORT. PLEASE CALL TO SCHEDULE A SITE VISIT.

©2011 OCP&E, LLC--ALL RIGHTS RESERVED.� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �

www.ocpe.us

OC

P&

E S

CR

UB

BE

R F

OR

MU

LA

2X

SCRUBBER FORMULA 2X IS PATENT PENDING AND SCIENTIFICALLY CREATED TO REPLACE OR AUGMENT CHLORINE DIOXIDE, SODIUM HYPOCHLORITE (BLEACH), SODIUM HYDROXIDE (CAUSTIC SODA), AND ACIDS IN BOTH PACKED BED WET SCRUBBER SYSTEMS AND MIST CHAMBER SYSTEMS. THIS CHEMICAL IS ALSO IDEAL FOR POLISHING BIOSCRUBBERS.

LOADED WITH ORDENONE� ENCAPSULATOR, SCRUBBER 2X BECOMES AN ODOR ERASER FOR SULFIDES, AMMONIA, MERCAPTANS, AMINES, AND CERTAIN ALDEHYDES. ORDENONE� IS A PROPRIETARY INCLUSION CLATHRATE COMPOUND WHICH HAS THE EXTRAORDINARY ABILITY TO REMOVE ODOR WITHOUT THE ADDITION OF PERFUMES OR MASKING AGENTS. THIS EXOTHERMIC CHEMICAL REACTION LOWERS THE VAPOR PRESSURE ON THE ODOR MOLECULE SO THAT THE ODOR BECOMES UNDETECTABLE. ASK YOUR SALES REPRESENTATIVE FOR A COMPLIMENTARY DEMONSTRATION ON UNDILUTED AMMONIA. THE REMOVAL RATES CAN BE QUANTIFIED WITH A GAS DETECTOR. WITH SCRUBBER 2X, USING ACIDS AND CHLORINE DIOXIDE TO CONTROL AMMONIA AND OTHER ORGANIC COMPOUNDS BECOMES OBSOLETE.

A BLEND OF IONIC, NON-IONIC, AND CATIONIC SURFACTANTS SCRUBS ODORS AS WELL AS PACKING MEDIA, CLEANING OFF FATS, OILS, GREASES, AND SCUM. THE SURFACTANTS ALSO SOLUBILIZE, EMULSIFY, AND CAPTURE ODOROUS SPECIES INTO THE WATER PHASE, ALLOWING FOR FAR SUPERIOR MALODOR CONTROL THAN WITH TRADITIONAL OXIDIZERS WITHOUT CREATING THE SCALING WHICH OCCURS FROM BLEACH/CAUSTIC REACTIONS. ACID WASHING THE SCRUBBER BECOMES OBSOLETE.

THE SURFACTANT BLEND IS READILY BIODEGRADABLE. BUILT-IN SILICONE DEFOAMER IS ADDED TO KEEP THE SCRUBBER SYSTEM FREE FROM FOAMING. UNLIKE OTHER CHEMICALS, SCRUBBER 2X IS NEAR NEUTRAL IN PH, NON-TOXIC, AND NON-HAZARDOUS.

SCRUBBER 2X CAN BE BLENDED AS AN ODORLESS COMPOUND. HOWEVER, MOST CLIENTS PREFER THE STANDARD FORMULA WHICH INCLUDES AN INDUSTRIAL STRENGTH CITRUS MINT DEODORIZER WITH LEMON TERPENES OR MEDITERRANEAN CITRUS BLEND TO FURTHER CONTROL ODORS AND ACT AS AN OLFACTORY GUIDELINE TO DETERMINE PRODUCT DOSING RATES. SCRUBBER 2X CONTAINS LESS THAN 2-5% VOC.

SCRUBBER FORMULA IS O.S.H.A. AND D.O.T. NON-HAZARDOUS. UNLIKE CHLORINE-BASED CHEMICALS, SCRUBBER 2X DOES NOT FORM CHLORINATED BY-PRODUCTS AND FORMALDEHYDE--KNOWN CARCINOGENS. ALWAYS REFER TO MATERIAL SAFETY DATA SHEET (M.S.D.S.) BEFORE USING THIS PRODUCT.

STARTING RECOMMENDATIONS FOR CONTINUOUS DOSING ARE AS FOLLOWS:RENDERING PLANTS: 1.5 to 5 FLUID OUNCES PER HOUR PER 5,000 C.F.M.WASTEWATER TREATMENT PLANTS: 1.5 to 5 FLUID OUNCES PER HOUR PER 5,000 C.F.M.

FOR ADDED CONTROL, MAINTAIN AT LEAST A 1-5% SOLUTION IN THE SCRUBBER SUMP. PRODUCT SHOULD BE DOSED INTO THE SCRUBBER VIA A CHEMICAL METERING PUMP. FOR MULTIPLE STAGE SYSTEMS, INJECT CHEMICAL INTO ALL TOWERS.

FOR ALL APPLICATIONS, INJECT THE CHEMICAL WITH A CHEMICAL METERING PUMP SET AT 100% SPEED; STROKE WILL VARY DEPENDING ON THE APPLICATION. MAINTAIN 100% SPEED TO AVOID ANY WATER-PRODUCT GAP EFFECTS.

FOR BIOSCRUBBERS, SCRUBBER FORMULA 2X CAN BE ATOMIZED IN OR AT THE TOP OF THE SCRUBBER EXHAUST STACK OR AROUND THE PERIMETER OF THE SCRUBBER WITH THE AQUAFOG� FANS OR FOGMASTER� JUMBO 90 CFM NOZZLES.

OC

PE&

OD

OR

CO

NT

RO

L P

RO

DU

CT

S &

EQ

UIP

ME

NT

©2011 OCP&E, LLC--ALL RIGHTS RESERVED.

www.ocpe.us