Nellcor™

Pediatric and Infant Reusable SpO2 Sensor Application Guide

Select a sensor site. For infants 3-15 kg, the preferred site is the big toe. For children 15-40 kg, the preferred site is an index finger, or alternatively, thumb, another finger or big toe.

Place the adhesive wrap on a flat surface, fabric side down. Remove the backing to expose both alignment holes.

Position the sensor so that notches in the wrap are centered on the side of the toe or finger.

Wrap the sensor around the site so the optical components are directly across from each other. Secure the adhesive wrap firmly but not too tightly, and anchor the cable with a piece of medical-grade tape.

Position the sensor on the wrap so the alignment bumps protrude through the holes. Press down firmly in the center to ensure the wrap adheres to the sensor. Remove the remaining backing.

COVIDIEN, COVIDIEN with logo, Covidien logo and positive results for life are U.S. and internationally registered trademarks of Covidien AG. ©2012 Covidien. All rights reserved. 12-PM-0111 SN12612

6135 Gunbarrel Avenue, Boulder, CO 80301 800-635-5267 www.covidien.com

Read the sensor’s “Directions for Use” insert for complete instructions for use, including all warnings, cautions and specifications, prior to use of this product.

4 5 6

1 32

Reusable SpO2 sensors can be used with Nellcor™ pulse oximetry with OxiMax™ technology and earlier-generation Nellcor™ oximetry.

If you have any questions, contact your Nellcor product representative at 800-635-5267.

Change sensor site at least every four hours. Do not throw away the reusable sensor. Discard adhesive wrap only. Wipe sensor with an agent, such as 70% alcohol, before reusing on another patient.

PEDIATRIC AND INFANT APPLICATION

OXI-P/I

ADH-P/I