FS140123 - REV: ORIG

DESCRIPTION:This document illustrates how to replace the Control Panel Assembly in your Model 721.(For units with serial numbers between J032774 - J032983 & J038710 - J038919)

Please review this document thoroughly before beginning repairs. Wisco recommends using qualified local service agents. Wisco does not have authorized service agents.

TOOLS NEEDED• Pliers (Needle Nose Recommened) • #2 Phillips Head Screwdriver

PARTS INCLUDED• (1) 0027114 - CONTROL PANEL ASSEMBLY

#1 #2

Page 1 of 3

MODEL 721 - CONTROL PANEL ASSEMBLY 0027114SK

FS140123 - REV: ORIG

1.) Remove the Door. (See door removal instructions)

2.) Remove door gasket. Grab gasket from any corner and gently pull out to remove.

3.) Remove the six screws along the bottom of the Con-trol Panel holding it to the Bottom Panel.

Page 2 of 3

UNPLUG UNIT FROM OUTLET AND ALLOW TO COOL

MODEL 721 - CONTROL PANEL ASSEMBLY 0027114SK

FS140123 - REV: ORIG

4.)Remove the front eight screws (RED Circles) of the Control Panel, and four screws (BLUE Rectangles) holding in the small corner brackets. Note the smaller sized screws that are located within the gasket channel.

Page 3 of 3

5.) Use a pliers to carefully disconnect the five wire connections from the Power Board. (Note Position of each wire)

6.) Assemble in reverse order and unit is ready for operation.

Wire Connections:#1 - Neutral#2 - Line#3 - Hi-Limit#4 - Hi-Limit#5 - Motor

#2#1

#3 #4 #5

MODEL 721 - CONTROL PANEL ASSEMBLY 0027114SK