Matrix and Interfaces overview

Digital Matrix with 15 user slots capable of 480 ports full-duplex communication ports housed in a 6RU frame. The total number of ports used depends on the different types of interface cards that are fitted into the matrix

Fail-safe redundancy achieved by two processor cards and two power supplies with failure alarm indication

Full compatibility with V panels and I-stations

Full audio bandwidth: 30 Hz to 22 kHz

Programmed and controlled by the Eclipse EHX Configuration Software.

OMEGA MATRIX

Eight general purpose inputs and eight relays, located directly on the matrix. MVX card with 16 ports for panel, audio and/or interface connection. The E-MADI64 is a MADI (Multichannel Audio Digital Interface) card,providing up to 64 duplex

channels of AES3 digital audio over a coaxial cable or fiber pair between compatible devices. Fibre card with dual redundant transceivers for networking matrices over Fibre optics E-Que – FreeSpeak Integra card for connection to antennas and FreeSpeak digital wireless

Beltpacks E-Que – E1/T1 card with dual for connection to telecom leased lines. Each E1 controller

provides 30 digital audio lines IVC-32 card supports 32 IP connections over LAN to V panels-IP or Concert PC clients LMC-64 card support audio metering of any input / output in a local or remote matrix

Individual level control and Programmable VOX Intelligent linking of up to 64 matrices DTMF inward access (incoming DDI support) Four separate configurations can be stored on-board, accessible from front button controls Remote access by Internet/Ethernet or RS232 Dual LAN connectors for redundancy

OMEGA MATRIX

Digital Matrix with up 7 user slots capable of 480 ports full-duplex communication ports housed in a 6RU frame. The total number of ports used depends on the different types of interface cards that are fitted into the matrix

Eight IMF slots to support Interface Modules (TEL-14, FOR-22, GPI-6, RLY-6, CCI-22 and AES-6 card)

Fail-safe redundancy achieved by two processor cards and two power supplies with failure alarm indication

Full compatibility with V panels and I-stations

Full audio bandwidth: 30 Hz to 22 kHz

Programmed and controlled by the Eclipse EHX Configuration Software

MEDIAN MATRIX

Eight general purpose inputs and eight relays, located directly on the matrix. MVX card with 16 ports for panel, audio and/or interface connection. The E-MADI64 is a MADI (Multichannel Audio Digital Interface) card,providing up to 64 duplex

channels of AES3 digital audio over a coaxial cable or fiber pair between compatible devices. Fibre card with dual redundant transceivers for networking matrices over Fibre optics E-Que – FreeSpeak Integra card for connection to antennas and FreeSpeak digital wireless

Beltpacks E-Que – E1/T1 card with dual for connection to telecom leased lines. Each E1 controller

provides 30 digital audio lines IVC-32 card supports 32 IP connections over LAN to V panels-IP or Concert PC clients LMC-64 card support audio metering of any input / output in a local or remote matrix

Individual level control and Programmable VOX Intelligent linking of up to 64 matrices DTMF inward access (incoming DDI support) Four separate configurations can be stored on-board, accessible from front button controls Remote access by Internet/Ethernet or RS232 Dual LAN connectors for redundancy

MEDIAN MATRIX

Digital Matrix with up 4 user slots capable of 480 ports full-duplex communication ports housed in a 3RU frame. The total number of ports used depends on the different types of interface cards that are fitted into the matrix

Three IMF slots to support Interface Modules (TEL-14, FOR-22, GPI-6, RLY-6, CCI-22 and AES-6 card)

Fail-safe redundancy achieved by two processor cards, two power supplies with failure alarm indication and two internal cooling fans (for redundancy)

Rear to front Ethernet / panel feed through Front handles for easier removal from the rack

Full compatibility with V panels and I-stations Full audio bandwidth: 30 Hz to 22 kHz

Programmed and controlled by the Eclipse EHX Configuration Software.

DELTA MATRIX

Eight general purpose inputs and eight relays, located directly on the matrix. MVX card with 16 ports for panel, audio and/or interface connection. The E-MADI64 is a MADI (Multichannel Audio Digital Interface) card,providing up to 64 duplex

channels of AES3 digital audio over a coaxial cable or fiber pair between compatible devices. Fibre card with dual redundant transceivers for networking matrices over Fibre optics E-Que – FreeSpeak Integra card for connection to antennas and FreeSpeak digital wireless

Beltpacks E-Que – E1/T1 card with dual for connection to telecom leased lines. Each E1 controller

provides 30 digital audio lines IVC-32 card supports 32 IP connections over LAN to V panels-IP or Concert PC clients LMC-64 card support audio metering of any input / output in a local or remote matrix

Individual level control and Programmable VOX Intelligent linking of up to 64 matrices DTMF inward access (incoming DDI support) Four separate configurations can be stored on-board, accessible from front button controls Remote access by Internet/Ethernet or RS232 Dual LAN connectors for redundancy

DELTA MATRIX

► Digital Matrix with up to 32 ports or High capacity link for connecting two Eclipse HX-PiCo matrix frames together, forming a non-blocking system of 72 ports.

► Full-duplex communication ports and four extra 4-wire ports housed in a 1RU frame.

► Front panel User Menu for dynamic system changes and system status monitoring

► Fail-safe redundancy achieved by two power supplies

► Full compatibility with V panels and I-stations

► Full audio bandwidth: 30 Hz to 22 kHz

► Programmed and controlled by the Eclipse EHX Configuration Software.

PICO MATRIX

► Eight general purpose inputs and eight relays, located directly on the matrix.

► Intelligent linking of up to 64 matrices ► Between any combination of E-Pico, Omega, Median and Delta matrices using analogue

trunks and IP

► DTMF inward access (incoming DDI support) only on port 17-32

► Individual level control and Programmable VOX

► Four separate configurations can be stored on-board, accessible from front button controls

► Remote access by Internet/Ethernet or RS232

PICO MATRIX

Eclipse HX MATRIX INTERFACES – GENERAL FEATURES

MVX-16 ►16 port matrix card with 16x RJ45 connectors for connection to Panels, 4wire and External

interfaces. ► Each MVX port uses a 8 pin RJ45 connector that contains bidirectional RS422 data and

Analogue 4wire audio► Status LEDs showing port status and audio presence status

E-FIB – Fibre networking card► Dual redundant optical transceivers for networking matrices together to form a fibre optic ring.

The fibre ring provides 1024 audio channels shared across all linked matrices (15 matrices in total) in the ring.

► The Fibre ring carries audio only. Matrix to Matrix data is carried separately using a LAN► Automatic switchover from ring A to ring B. Auto loopback in case of any breaks in the ring► Two cards can be placed in a matrix to provide card redundancy as well ring redundancy

MATRIX INTERFACE

Eclipse HX MATRIX INTERFACES – GENERAL FEATURES

E-QUE – FreeSpeak Integra►The FreeSpeak Integra card provides integrated control of FreeSpeak Beltpacks. ►The FreeSpeak beltpacks are registered to the matrix using HX and can then be programmed

like panels to access any local or remote port on the system. ► Up to 4 cards can be fitted in a matrix giving access to 40 antennas in one matrix that can be

spread across the building allowing the beltpacks to roam from one area to another without losing connection

► The card can be set into 2 modes. ► Mode 1 antenna mode - 8x RJ45 connectors for directly connected antennas► Mode 2 splitter mode - Using RJ45 #1 and RJ45#5 provides connection to 10 antennas via

splitter units.

E-QUE- E1/T1 line card ►Dual E1/T1 line card for connection to telecom 2MB (E1) / 1.5MB (T1) lease lines.► When set for E1 mode provides 30 digital audio channels using 1x CAT5 cable . The card can

be set up for trunklines or tie-lines (60 lines in total on one card)► When set for T1 mode provides 24 digital audio channels using 1x CAT5 cable . The card can

be set up for trunklines only (48 lines in total on one card)

MATRIX INTERFACE

Eclipse HX MATRIX INTERFACES – GENERAL FEATURES

IVC-32 IP card ► Provides 32 channels of IP connection to IP enabled V panels or Concert PC clients or

Trunklines ► Each channel supports low latency G722 (7Khz audio)► Allows direct connection of V panel-IP over LAN or internet ►IVC-32 card supports functions as a hot redundant backup for one or more IVC-32-HX cards in

the same frame►IVC-32 cards supports directs and trunks over IP network infrastructure

LMC-64 Metering card ►Used in conjunction with the Production Maestro HX plug-in► Provides up to 64 real time metering meters for input / outputs. To check the levels entering

and leaving the matrix ► Can also monitor the overall audio level of a conference.► Provides both Nordic 9 and VU scales ► A single card can monitor levels across a network of matrices

Note: Maximum of 4x E-Que / IVC-32 / LMC-64 cards in any combination can be fitted into a single matrix

MATRIX INTERFACE

Eclipse HX MATRIX INTERFACES – GENERAL FEATURES

E-MADI64 Card The E-MADI64 is a MADI (Multichannel Audio Digital Interface) card,providing up to

64 duplex channels of AES3 digital audio over a coaxial cable or fiber pair between compatible devices

E-MADI64 Card Properties permits sample rate selection when synching to video signals. The E-MADI64 card must be configured before it can be used when not using the Word Clock Source Sync.

E-MADI64 Card Properties always defaults to the E-MADI64 standard for the number of channels.

MATRIX INTERFACE

Eclipse HX MATRIX EXTERNAL INTERFACES – GENERAL FEATURES

IMF-3 Frame► Can house up to 11 Interface Modules in 3U.

► PSU LED indicators on front panel.

► Requires power from a PSU-101 module

IMF-102 Frame► Can house up to 2 Interface Modules in 1U.

► Integral PSU module

EXTERNAL MATRIX INTERFACES

FOR-22 DUAL FOUR WIRE INTERFACE► Provides two independent 4-wire/radio interfaces with transformer

isolation.

► Each channel has separate 1x relay output, 1x opto isolated input

► Separate send and receive level controls on front panel

► Connects to a matrix (MVX) port using CAT5 cable

► Applications include: camera intercomms, two way radios, satellite links, IFBs and program audio.

EXTERNAL MATRIX INTERFACES

CCI-22 DUAL PARTY LINE INTERFACE► Provides connection to two independent 2-wire party-line systems

► Supports Clear-Com and many other party-line formats.

► Audio signals are transformer balanced, Control signals are opto isolated.

► Signal level and auto-“null” controls are on the front panel.

► Connects to a matrix (MVX) port using CAT5 cable

TEL-14► Provides two independent auto-nulling Telephone Interface lines.

► Supports manual and speed dialling telephone access

► DTMF inward access for Self-service dial-in or Party-line dial-in (DDI access)

► Connects to a matrix (MVX) port using CAT5 cable

EXTERNAL MATRIX INTERFACES

AES-6-CX INTERFACE► Provides connection to six independent Intercom panels via Coax

► Connects to a matrix (MVX) port using CAT5 cable

► Provides 6 mono or 3 stereo panel feeds

► Support Vpanels and 4000 panels fitted with coax daughter cards

AES-6-RJ INTERFACE► Provides connection to six independent AES-3 streams.

► Connects to a matrix (MVX) port using CAT5 cable

► Provides 6 mono or 3 stereo audio feeds

► Connects to external AES-3 external devices (96/48K)

► 24Bit audio + 8bit user control data

► Vpanels can also be connected by RJ45-digital CAT5

EXTERNAL MATRIX INTERFACES

RLY-6 RELAY INTERFACE► Provides connection to six independent single pole, double throw (SPDT) relay

outputs.

► Test pushbutton on front panel and LED indication for each set of relay contacts.

GPI-6 GENERAL PURPOSE INTERFACE► Provides connection to six general purpose logic inputs.

► Logic inputs can activate functions (audio routes, signalisation) within the Matrix frame defined by HX

► Opto Isolated inputs. LED indicator for each GPI activation.

► Test pushbutton on front panel to provide local activation of the logic input as defined by HX

GPI/RLY cards connect to the CPU card directly using a CAT5 cable the to GPI/RLY DATA connector on the CPU rear card on the Matrix. They can be daisy chained to other RLY-6/ GPI-6 cards using CAT5 cable with the first in the chain connecting to the CPU REAR card

EXTERNAL MATRIX INTERFACES

Thank you!