©schoolofpiping.com Page 1

MAKING A SET OF BAGPIPES www.schoolofpiping.com

Kintail Bagpipe Makers of Glasgow have kindly supplied a series of photographs showing the making

of a set of the KB2 bagpipes as sold at the School of Piping Shop. We thought this would be a good

opportunity to combine the photographs into an article showing how a set of bagpipes are turned.

The timber is supplied in a rough sawn state, cut into blocks, square in section, and of a finished

length. It must be straight grained, properly seasoned and free from defect. The first stage in

converting these blocks into a set of bagpipes is to mount them in a lathe and machine the exterior

round. The primary bore is made using a specialised drill capable of producing a straight and clean

surface. Any secondary boring (e.g. the larger diameters in drone top sections), is then undertaken

with larger drills.

Once the bores are done, work on the exterior shaping can begin. Some of the basic shaping can be

done by way of some simple profiling tools or by an experienced eye whilst the timber is still in the

lathe. Surfaces such as the compound curves on the drones are produced by hand. Needless to say, a

steady hand and a good eye is required to produce profiles that look right and are consistent across

a set.

©schoolofpiping.com Page 2

Above shows a stock being shaped

Blanks for mounts are added to the shaped pieces and then turned to shape. The photographs below

show projecting mounts on a tenor lower section being shaped.

©schoolofpiping.com Page 3

The following photographs show a ring cap on a drone top being shaped.

The drone top is the shaped prior to beading and combing.

The complex decorative exterior shaping known as combing and beading can now be applied. Much

practice is required to produce accurate and attractive combing and beading as this is applied

entirely by hand on the wood lathe.

©schoolofpiping.com Page 4

Above shows combing patterns being applied to a tenor top.

Above shows beading patterns being turned.

Threading for hemping being turned on the pin of a lower drone section.

©schoolofpiping.com Page 5

A finished drone section.

A finished Chalice Bagpipe following waxing.

Another finished product, a set of full silver Kintail bagpipes.

Kintail Bagpipe Makers of 113 Barrack Street, Glasgow produce a fully handmade product

manufactured by master craftsmen with years of experience in their art. The drones they

manufacture are based on the Henderson tradition with founder Greig Sharp having been the

©schoolofpiping.com Page 6

Manager of Peter Henderson Ltd for some years. The drones produce a sonorous, full tone with

excellent steadiness and are very easy to set up and reed. More of their products can be seen at

http://www.kintail.co.uk/

We wish to thank Drew and Stephen Sharp of Kintail Bagpipe Makers for supplying the photographs

used in this article and for their support of the School of Piping website.

More information and further pictures of bagpipes being made are to be found in “The Complete

Pipers Handbook” which helps to fund this freely available site. The book is available here:

http://www.schoolofpiping.com/handbook.html