magnetic digital readout - primadilna · magnetic digital readout the lathe features a magnetically...
TRANSCRIPT
MAGNETIC DIGITAL READOUT
The lathe features a magnetically mounted DRO (see Figure 1 ) for X-axis (cross slide) and Z-axis (carriage) travel.
Note: When placing the DRO, locate all cables so they do not interfere with machine operation and cannot be pinched by moving components.
The X-axis and Z-axis scales are attached to the cross slide and bed (respectively). Shielded cables run from each sensor to plugs on the back of the DRO (see Figure 2 ). The DRO connects to a regular 240V power supply with a dedicated power cord using a correct plug.
Digital ReadoutA. DRO displays current position of X-axis and
Z-axis in hundredths of a millimeter or thou-sandths of an inch. (Included Y-axis display line is not used on the lathe)
B. "X" value displays total X-axis travel from zero along cross slide.
C. "Z" value displays total Z-axis travel from zero along lathe bed.
D. In/MM button allows users to toggle measurement display in either inches or millimeters.
E. ZERO buttons reset values at any point along the axis to 0.00.
F. Green light indicates inches or millimeters.
G. Magnetic mount.
DRO(Viewed from behind)
240 VACAW
NEUTRAL
HOT
Z-Axis Sensor
X-Axis Sensor
Z-Axis Port
PowerCordPort
POWER
Y-Axis Port(Not Used)X-Axis Port
CXM-3
Figure 2. DRO wiring.
Figure 3. DRO controls and display.
B
C
DF
E
A
Using DRO
Figure 1. DRO magnetically mounted on lathe headstock.
Z-Axis Port
DRO Power Cord
G
X-Axis Port
Y-Axis Port(Not Used)
ON/OFF Switch